Vibration velocity sensor SZ-6 TL-6 ST-6 vibration probe

Vibration velocity sensor SZ-6 TL-6 ST-6 vibration probe

Introduction:Vibration velocity sensor SZ-6 TL-6 ST-6 vibration probeMainly installed on bearing covers of various rotating mechanical devices (such as turbines, compressors, fans, and pumps). It is an electromagnetic sensor that outputs voltage by cutting magnetic field lines with a moving coil, and therefore has the characteristics of not requiring power supply during operation and easy installation. Installation position: Install vertically or horizontally on the measured vibration point, and fix the bottom of the sensor with M10 × 1.5 screws.

Equipped with CZJ-B2 and CZJ-B3 vibration monitoring and protection devices, it can measure the bearing vibration of various rotating machinery, detect various faults of rotating machinery early, output standard 4-20mA current signals, and send them to PLC, DCS, DEH systems, etc.

Electrical indicators:

1. Sensitivity: 20/30/40/50/100mv/mm/s

2. Frequency response: 10 to 1000 Hz

3. Natural frequency: 10Hz

4. Measurable amplitude: ≤ 2000 μ m (P-P)

5. High acceleration: 10g

physical indicators：

1. Dimensions: φ 32 × 78mm

2 Weight: Approximately 350g

3. Measurement direction: vertical or horizontal

Environmental indicators：

Temperature: -10 ℃ to+100 ℃, relative humidity ≤ 90%

Ordering Guide:

SZ-6-AXX—BXX—CXX

Measurement directionAXX：

01- Vertical

02- Level

03- Dual use vertical and horizontal

Connector option BXX: 01- Aviation plug

02- Direct lead wire

03- Wiring terminals

Cable length CXX: ordered in increments of 1 m, for example: 010=1.0m default m