Magnetic electric speed sensor SZ-6 (k) SZ-6A SZ-6 Jiangyin

Magnetic electric speed sensor SZ-6 (k) SZ-6A SZ-6 Jiangyin

Magnetic electric velocity sensor is an inertial sensor that uses the principle of magnetic electric induction to convert vibration signals into voltage signals. The voltage value is proportional to the vibration velocity value and has the advantages of high signal-to-noise ratio and low output impedance. It is widely used.

Sensitivity: SZ-6K: 20mV/mm/s, with an error of ± 5%;

Test conditions: (measured at a temperature of 20 ℃± 5 ℃, 80Hz, and a speed of 10mm/s).

Amplitude limit: ≤ 2000 μ m (peak to peak).

Frequency response: SZ-6K: (10~1000) Hz;

Maximum acceleration: 10g.

● Operating environment temperature: (-40~+70) ℃.

Relative humidity: ≤ 95% RH (non condensing).

Working environment: There is no strong magnetic field or corrosive gas or liquid around.

● Dimensions: Φ 35 × 78 (mm).

Weight: Approximately 200g;

Installation method: Fixed with double headed screws.

Mainly installed on bearing covers of various rotating mechanical devices (such as turbines, compressors, fans, and pumps). It is an electromagnetic sensor that outputs voltage by cutting magnetic field lines with a moving coil, and therefore has the characteristics of not requiring power supply during operation and easy installation. Installation position: Install vertically or horizontally on the measured vibration point, and fix the bottom of the sensor with M10 × 1.5 screws.

Equipped with CZJ-B2 and CZJ-B3 vibration monitoring and protection devices, it can measure the bearing vibration of various rotating machinery, detect various faults of rotating machinery early, output standard 4-20mA current signals, and send them to PLC, DCS, DEH systems, etc.

Ordering Guide:

SZ-6K-AXX—BXX—CXX

Measurement directionAXX：

01- Vertical

02- Level

03- Dual use vertical and horizontal

Connector option BXX: 01- Aviation plug

02- Direct lead wire

03- Wiring terminals

Cable length CXX: ordered in increments of 1 m, for example: 010=1.0m default m

Magnetic electric speed sensor SZ-6 (k) SZ-6A SZ-6 Jiangyin