T-03S magneto electric speed sensor paired with SZC-KYPN speedometer

T-03S magneto electric speed sensor paired with SZC-KYPN speedometer

1、 Introduction:

T-03S magneto electric speed sensor paired with SZC-KYPN speedometer Using the principle of electromagnetic induction to achieve speed measurement. This sensor has strong output signal, good anti-interference performance, easy installation and use, and can be used in harsh environments such as smoke, oil and gas, water and gas. It is a passive two-wire magnetoresistance sensor.

2、 Electrical indicators:

• DC resistance: 200 to 600 Ω (25 ℃)

• Working temperature: -25 to+85 ℃

• Measurement range: 200~15000r/min

3、 Physical indicators:

• Weight: Approximately 120g

• Anti vibration: 20g

• Thread specification: M16 × 1

• Gear material: Gear materials should be made of metal materials with strong magnetic permeability.

• Tooth profile: Forming an involute tooth profile is a suitable tooth profile. Using large modulus gears or other tooth profiles will result in significant waveform distortion, which will hinder accurate measurements. If the spindle has axial movement, it should be noted that the center of the magnetic pole should be at the center position of the gear.

Gear module: 2 to 4 tooth width b: greater than 5mm.

4、 Environmental indicators:

• Working temperature: -10 to+120 ℃

5、 Ordering Guide:

• -AXX—BXX—CXX—DXX

Sensor length AXX: 01-60mm

02-80mm

03-120mm

04- Special specifications (length 300mm)

Thread specification BXX: 01-M16 × 1

02- Special Specifications

Cable length CXX: ordered in increments of 1 meter, for example: 010=1.0m,

Default 2m

Connector options DXX: 0 1- Direct lead wire

0 2- Aviation plug