- Phone
-
Address
L19-005, Building L19, South China International Leather and Leather Raw Material Logistics Zone (Phase I), No.1 South China Avenue, Hehua Community, Pinghu Street, Longgang District, Shenzhen City
Product Categories
Shenzhen Yimai Optoelectronics Co., Ltd
position sensor
NegotiableUpdate on 05/07
- Model
- Nature of the Manufacturer
- Producers
- Product Category
- Place of Origin
Overview
LCAMV6-PSD is a one-dimensional PSD with a narrow photosensitive surface, sealed in a surface mount chip carrier package. 0.7 The 24mm $r $n photosensitive mask has excellent position detection characteristics, adopts a low-noise circuit design, adjustable circuit gain, 16 bit ADC, TTL interface and Type-C USB $r $n interface. USB adopts virtual serial port technology, no need to install driver programs, and can be used in the same way as serial ports. The acquisition speed is above 10KHz, and there is a TTL interface, which facilitates the interconnection between $r $n and TTL modules and can be externally triggered for control.
Product Details
position sensorThe main characteristics are:
1. 16 bit sampling, adjustable gain;
2. High speed USB virtual serial port (VCP), speed>10KHz;
3. Has TTL interface, UART interface, can trigger synchronization externally;
4. Can simultaneously detect light intensity and position, with a position accuracy of 1um
5. Support secondary development, provide SDK, support C++, C #, Python;
6. System support: Windows, Linux, MAC, Android
Main technical parameters:
model |
LCAMV6-PSD-S8543 |
|
Chip type |
HamamatsuS8543 |
|
Detector material |
silicon（SI） |
|
Detection surface size |
0.7 ×24 mm |
|
Spectral response range |
320-1100nm（Peak：960nm） |
|
interface |
USB-Type C，TTL，Uart |
|
sensitivity |
0.58A/W |
|
Position detection error |
±50um |
|
position resolution |
0.6um |
|
TTLSerial port baud rate |
115200/384000/921600switchable |
|
Collection rate |
USB>10KHz |
|
power consumption |
5V@0.2A |
|
power supply |
3.0---5.5V |
|
SDKSupport: |
QT C++,Python,C# |
|
spectral response |
|
|
TTL interface (connector 1.25-10Pin):
|
5V |
power input,3-5.5Vscope |
2 Pin |
USB DP |
USB D+ |
2 Pin |
USB DM |
USB D- |
4 Pin |
GND |
GND |
5 Pin |
UART RX |
UARTReceive pins,3.3V |
6 Pin |
UART TX |
UARTSend pins,3.3V |
7 Pin |
NC |
suspended in midair |
8 Pin |
Trigger |
|
9 Pin |
GPIO3 |
Programmable output pins |
8 Pin |
NC |
suspended in midair |
Trigger
The pin is an external trigger pin, with a 3.3V level and a maximum of 5V.
Software usage: After plugging in the USB cable, open the Device Manager and find the corresponding port number, as shown in the following figure
Open the software, select the corresponding port number, and open the device:
