- Phone
-
Address
No. 76 Jinma Road, Jiufu Development Zone, Songjiang District, Shanghai
Shanghai Dapeng Automation Control Equipment Co., Ltd
SMC Boost Valve VBAF Series
NegotiableUpdate on 05/20
- Model
- Nature of the Manufacturer
- Producers
- Product Category
- Place of Origin
Overview
Boosting valve VBAF SMC $r $n ● CO2 emissions (compressed air consumption) are reduced by 25% to 30% $r $n ● Factory air local boosting can reach up to 4 times $r $n ● Fully pneumatic, without the need for power supply #183; Easy installation $r $n ● More than 50 million actions (boost ratio 2/4 times) ※ According to our company's testing conditions $r $n ● Pressure reducing valve $r $n ● Magnetic switch $r $n ● Pressure gauge (OUT side) $r $n ● Vertical #183; Horizontal installation $r $n ● Can be installed interchangeably with existing products (VBA series)
Product Details
Residual pressure treatmentWhen it is necessary to quickly release the residual pressure on the outlet side for maintenance purposes, please connect a three-way valve on the OUT side of the booster valve (see figure below). For those connected and releasing residual pressure on the IN side, the one-way valve inside the booster valve will still function, and the pressure on the outlet side cannot be discharged. Please be sure to note that after the operation is completed, please cut off the supply pressure on the inlet side. Stop the action of the boost valve to prevent unnecessary air consumption.
Quality of gas sourcePlease install an air filter. Please install an air filter on the inlet side of the booster valve and select a filtration accuracy of less than 5 μ m. Please install aftercoolers, air dryers, and water droplet separators to ensure air quality. Compressed air containing a large amount of condensed water can cause poor operation of valves and other pneumatic components. Please install devices such as aftercoolers, air dryers, and water droplet separators for appropriate treatment. In situations where there is a lot of carbon powder, please install an oil mist separator on the upstream side of the valve for filtration and removal. When the air compressor produces a large amount of carbon powder, if the carbon powder adheres to the inside of the valve, it will cause poor operation.
Counting the number of actions takenWhen using a magnetic switch for counting the number of actions, please use components with a counting speed of not less than 1kHz.
