Precision booster electric mixer brushless motor

Precision booster electric mixer brushless motor

1、 Characteristics

Precision booster electric mixer brushless motorisJJ-1Improved on the basis of precision power increasing electric mixer, this machine adopts constant speed instrument control, and the motor uses brushless DC motor, which has high torque, stable speed, can work continuously for a long time, without noise. The mixing rod is made of stainless steel, which enhances the corrosion resistance. Widely used in laboratories of various universities, environmental research, health, epidemic prevention, petroleum, metallurgy, chemical, medical, food and other units, it is a commonly used tool for laboratory technicians.

3、 Performance

Power supply voltage:220V 50HZ

Total machine power: 300W(Brushless motor)

maximum speed:3000r/min

timing range0～9999min

Control method:Instrument settings

3、 Usage method

Firstly, check if the random accessories are complete. Then, install the branches on the black base in order on a flat and firm workbench (tighten them with a wrench). Install the motor connector and check if the motor is securely fixed. After installation, calibrate the mixing rod and keep the motor wire away from it,Connect the power again, set the time, and turn the speed control knob from slow to fast (do not start at high speed). To ensure safety, it is necessary to use a grounding wire to avoid accidents, and the instrument should be kept clean and dry. The constant speed model comes with additional instrument instructions!
The instrument operation is as follows:

Example: Set the mixer to operate at a rate of per minute500Next job120Stop working in minutes.

1Turn on the power switch, and the upper row will display the original speed value.(Last run speed)The bottom row displays the original timing values.

2According to the ︾(Speed fast/slow)Set the speed to500.

3Press ▲ (Up key) Set the timing to120.
4Press the ▼ (down arrow) to adjust the timing downwards (setting 0 points indicates continuous operation with an indefinite opening)
5 Press the RUN button to start the machine, and it will slowly start until it reaches 500 revolutions per minute. At the same time, the timer will start (countdown), and then run steadily for 120 minutes before stopping. The END alarm will be displayed for 10 seconds. Timed operation completed.
6Speed and time adjustments can be made during both standby and timed operation.

7: PressSTOP(stop button)It can be stopped at any time (at which point the scheduled time also ends).

8:The green light is the running light, and the red light is the stop light. The corresponding indicator light is on, indicating that the controller is in the corresponding state.