Powder angle of repose tester

NegotiableUpdate on 05/06

Model

Nature of the Manufacturer: Producers

Product Category

Place of Origin

Online Consult

Overview

The usage method of the powder angle of repose tester refers to GBT 16913-2008 Dust Physics Test Method and GB/T 18702-2002 Coal Angle of repose Measurement Method. It is also applicable to the measurement of the angle of repose of other products, similar to the above measurement method.

Product Details

powderAngle of repose testerThe usage method refers to GBT 16913-2008 Dust Physics Test Method and GB/T 18702-2002 Coal Rest Angle Determination Method, which are also applicable to the rest angle measurement of other products, similar to the above measurement method.

FT-104AAluminum oxide/Aluminum fluorideAngle of repose tester

According to the standardGB/T6609.24-2004Design and manufacture of "Chemical analysis methods and physical property determination methods for alumina: determination of angle of repose". Used to determine the angle of repose of powders in their natural flow state.

1、 conform toYS/T581.13Chemical analysis methods and physical property determination methods for alumina Technical specification for determination of angle of repose..
2The product meets the requirements of easy use and maintenance, safety and reliability, economic rationality, and practical beauty.
3Installation, debugging, and usage methods of instruments
4Confirm that the experimental platform for placing this instrument is in a horizontal state,
5According toYS/T581.13Chemical analysis methods and physical property determination methods for alumina Install the instrument according to the assembly diagram and technical specifications in "Determination of Rest Angle".

How to use the powder angle of repose testerInstallation of instruments.
1Place the height fixing block at the discharge port and secure the funnel with fastening screws. One guarantee40mmHeight value

2Loosen the fixing screws of the funnel bracket and adjust the center point of the funnel to be perpendicular to the floor.

3Complete the test according to the standard requirements

FT-104AaluminaAngle of repose testersatisfy GBT 16913-2008Dust physics test methods andGB/T 18702-2002The method for measuring the angle of repose of coal is also applicable to the measurement of the angle of repose of other products, similar to the above measurement method.

Stainless steel funnel: upper inner diameter74mmInner diameter of discharge port6mm

heavy Quantity: Approximately16kg

Aluminum fluoride resting angleMeasurement device

Rest angle measuring deviceIt mainly includes the following parts:

1Stainless steel funnel: inner diameter of 74mm, inner diameter of 6mm at the discharge port, and a sieve with a diameter of 1mm is installed between the two plates. This funnel is fastened to the bracket.

2Electroplated steel base plate: The base plate is made of steel or corrosion-resistant materials such as marble and stainless steel. The smallest size is 200mm wide, 270mm long, and 18mm thick. Four 45 stripes are engraved on the surface of the polished and electroplated base plate. The straight line of the angle. There is a fixed height gauge positioning pin located in the center of the funnel, and three adjustable horizontal support feet under the bottom plate.

3Funnel holder: Made of stainless steel, its structure should be securely fastened. The centerline of the funnel is perpendicular to the central positioning pin.

4Height gauge (metal cylinder that determines height): It is a polished stainless steel cylinder with a height of 40mm and a groove at the bottom to connect with the positioning pin center of the base plate.