Portable smoke analyzer

It is Madu's largest analyzer equipped with electrochemical sensors. $r $n can be equipped with up to 7 electrochemical sensors and 4 infrared sensors. The $r $nGA-60 has a large (320 * 240) image LCD display screen with backlight function. It also has a data logger that can be inserted into an SD card to store detection results, as well as an embedded ribbon printer suitable for standard paper (non thermal).

Portable smoke analyzer，GA60

It is Madu's largest analyzer equipped with electrochemical sensors.

Can be equipped with up to 7 electrochemical sensors and4An infrared sensor.
The GA-60 has a large (320 * 240) image LCD display screen with backlight function.

It also has a data logger that can be inserted into an SD card to store the test results,

And an embedded ribbon printer suitable for standard paper (non thermal).

The analyzer provides the following two versions：

AAn analyzer with basic configuration, but without a gas dryer, that can work together with a probe holder and gas probe. It can be equipped with a PGD-100 gas dryer with a heating tube.

BEquipped with an embedded electrolyte gas dryer and heating tube---This configuration is particularly suitable for measuring gases that are highly sensitive to moisture or gases that are easily affected by water (SO2, HCl, NO2, Cl2)

Product Features:

●Up to 7 electrochemical sensors can be equipped

●Equipped with at most4An infrared sensor

●A ribbon image printer with embedded 58mm specifications

●It can measure gas and ambient temperature, and can be equipped with 8 additional temperature sensor input interfaces depending on the situation

●The built-in rechargeable battery can work at most16Hour (for basic configuration analyzer equipped with probe clamp and detection tube)

●Additional gas filter with condensation tank (installed on the lid)

●Differential pressure sensor - used to measure chimney ventilation and flow rate (with the help of a pitot tube)

●Equipped with smoke and dust measurement program

●Analog output (4-20mA/0-10V) - optional

●Data logger with SD card for storing results

●Equipped with gas calibration firmware

●Can calculate many additional parameters

For Type A analyzer:

Should be used together with Madu standard probe clamp and probe tube

Can be used with full-size gas dryers (such as PGD-100)

Use together.

For B-type analyzer:

The built-in electrolyte dryer is equipped with a peristaltic pump for removing condensation

Provide heating tube driver

Can be connected to heating tubes equipped with embedded heating gas filters

Working together with standard M30x1 fittings

Applicable to all probes with K-typeThe gas probe