Pneumatic punching machine

Pneumatic punching machineSuitable for cutting rubber, tape, leather, soft plastic, and foam in the laboratory For the cutting of soft materials, various cutting knives or dumbbell cutters can be used to cut test pieces of various specifications for tensile strength, tear, elongation, aging, sample, and other tests. This machine is powered by air pressure and only needs to be connected to an air pressure source to operate. It can also be used as a small press.

1、 Specifications:

1. Size: 55cm × 40cm × 67.2cm

2. Pressure plate: d: 12cm

3. Cylinder output: 1-5 tons (adjustable)

2、 Installation:

1. Place it on a flat surface.

2. Connect d outside: 8mm, d inside: 5mm trachea.

Configuration: One host, one air pipe, and one rubber plate.

IIIPneumatic punching machineOperation:

1. Place the slicer on a flat surface, adjust the four feet to be stable, and put on the cutting adhesive.

2. Turn on the gas source, adjust the valve switch of the oil-water separator at the back, and adjust the pressure gauge to at least 4KG.

3. Place the PU adhesive, the film on the cutting adhesive, and then place the knife mold. Then, press the red button switch with both hands simultaneously (for safety, both hands must press it at the same time), and press the pressure plate down onto the knife mold for a few seconds to fully cut off the rubber. Finally, let go and take out the test piece.

4. After use, please turn off the gas source.