GCS400 type resistive rotary switch

NegotiableUpdate on 05/16

Model

Nature of the Manufacturer: Producers

Product Category

Place of Origin

Online Consult

Overview

Using high-quality synchronous motors from the United States for reliable driving, the clutch system is suitable for a wide range of sensing structures

Product Details

Product Features

Using high-quality synchronous motors from the United States for reliable driving, the clutch system is suitable for a wide range of sensing structures

Explosion proof type with good economy is widely used in solid material switch measurement in various industrial fields.

Working principle

A synchronous motor drives the metal shaft and blades through a gear reduction structure. When the rotating metal blade is subjected to

When the upper obstruction of the detection material stops, the detection mechanism will drive the limit switch to act and output the amount of material on/off switch

Signal and simultaneously turn off the synchronous motor in operation. When the detected material descends, the resistance of the metal blades disappears,

The detection agency also drives the limit switch to operate, outputs a no material switch signal, and starts synchronous operation at several points,

Such repetitive testing work

Technical Parameter

·Measurement range

Used for measuring the upper and lower limit switch output of solid material level

·Applicable medium particles

Material unit particle size ＜ 50mm

·Medium temperature

Standard type: -20 ℃ -+100 ℃ High temperature type: -20 ℃ -+200 ℃

·Environmental temperature

-20℃—+80℃

·Medium density

≥0.2g/cm²

·Signal output

Passive or active contact switch signal output when reaching the limit

·Switch contact capacity

250VAC 5A PLC relay 48VDC 100Ma

·Switch delay

About 2 seconds

·Drive motor

220VAC power is approximately 4VA

·Drive shaft load

Standard axis ＜ 60N Reinforced axis ＜ 1500N High temperature axis ＜ 1500N

Soft shaft ＜ 1500N

·Allow work pressure

＜1500N0.05MPa

·Material rotation axis

The material of the part in contact with the medium is stainless steel 304 or other requirements are agreed upon

·Non contact with the medium

Shell reinforced engineering plastic PBTB

Partial materials

Die cast aluminum+epoxy coated bearings NBR rubber

·Process Connection Standard

External thread G1 1/2”Flange GB9119-2000 DN65PN0.6MPa

·Cable entry port

Internal thread M20 × 1.5 (with cable sealing sleeve)

·Protection level

IP65

·Explosion proof standard

Dust explosion-proof Zone10

Order Selection Table

Working principle	A synchronous motor drives the metal shaft and blades through a gear reduction structure. When the rotating metal blade is subjected to
	When the upper obstruction of the detection material stops, the detection mechanism will drive the limit switch to act and output the amount of material on/off switch
	Signal and simultaneously turn off the synchronous motor in operation. When the detected material descends, the resistance of the metal blades disappears,
	The detection agency also drives the limit switch to operate, outputs a no material switch signal, and starts synchronous operation at several points,
	Such repetitive testing work