Food grade mixing tank 304 liquid mixing and blending tank

Stainless steel mixing tank is a widely used mixing equipment in multiple industries.

Here is a detailed introduction:

-Structural composition: It mainly consists of a mixing tank body, mixing tank cover, mixer, support, transmission device, shaft seal device, etc. Heating or cooling devices can also be configured according to process requirements. The mixing tank body and tank cover can be connected by flange sealing or welding, and process pipe holes for feeding, discharging, observation, temperature measurement, etc. can be opened. The transmission device on the upper part of the mixing tank cover drives the mixer by the transmission shaft. The shaft sealing device can adopt various forms such as machine seal, packing, labyrinth seal, etc. The mixer has various forms such as slurry type, anchor type, frame type, spiral type, etc. to choose from.

-Material selection: Usually made of stainless steel 304 or 316L, it has good corrosion resistance, high temperature resistance, smooth surface, easy cleaning and disinfection, and meets the hygiene requirements of industries such as food and medicine.

-Heating and cooling methods: There are two heating methods: circulation of hot oil and other media, and direct electric heating. Hot oil circulation refers to the circulation of heat transfer oil through a hot oil pump after being heated in a heating tank; Direct heating is the installation of an electric heating tube on the jacket to raise the temperature of the heat transfer oil. The cooling cycle uses water to circulate inside and outside the jacket, so that the material does not clump or maintain appropriate viscosity at a certain temperature.

-Application areas: Widely used in industries such as coatings, pharmaceuticals, building materials, chemicals, pigments, resins, food, scientific research, etc., it can be used for material mixing, blending, blending, homogenization and other operations to meet the needs of different processes and production.

-Installation and commissioning: It is necessary to check whether the equipment has been damaged during transportation. Pre embedded anchor bolts should be used for horizontal installation, and the equipment, electrical control devices, and accessories should be installed under the guidance of professionals. The pipelines and instruments should be checked. Before starting, ensure that there are no obstacles in the surrounding area. After a few seconds of trial operation, if there are no abnormalities, a short-term trial run should be carried out. For those equipped with mechanical seals, lubricating oil should be injected and cooling water should be introduced. After adjusting the position of the mechanical seal, normal operation can be carried out.