Brand of Light Incubator Manufacturer

The brand of the light incubator manufacturer is trustworthy

Light incubator manufacturerThe appearance of the brand (hereinafter referred to as the incubator) is vertical. The box body and outer box door are made of steel plates and coated with plastic on the surface. The box door adopts tempered glass observation window, which can clearly and directly observe the cultivation items inside the box. The working room (inner tank) is made of stainless steel sub arc welding, and the height of the shelf can be changed arbitrarily. The outer door and the magnetic door seal of the box are used to ensure the sealing performance of the studio. The studio adopts a "U" - shaped water tank for water-resistant heating. There is a water inlet on the upper left side of the box, a water outlet on the lower left side, and an overflow rubber hose on the left back. The back of the studio is equipped with a low-noise small fan, ensuring uniform temperature inside the box. The outer shell of the box and the workshop are filled with ultra-fine glass wool for insulation. The temperature control system consists of sensors (Pt100 platinum resistors), temperature controllers, heaters, etc. When the temperature controller receives the sensor output resistance signal (100 Ω at 0 ℃, 0.3 Ω/℃), it measures the actual temperature in the working room displayed on the PV screen. When the input signal is less than the set value, the power transistor (bidirectional thyristor) conducts, allowing the heater to obtain sufficient electrical power to generate heat. On the contrary, the power tube does not provide electrical power output, and the heater does not heat up. The temperature controller has functions such as PID regulation output characteristics, adjustable electric power output size, error correction of temperature measurement, timing control and change, as well as safety functions such as lighting for over temperature or high/low water level and automatic output cut-off alarm.

IIBrand of Light Incubator ManufacturerNotes:

When opening the packaging box, the appearance of the equipment should be checked for any damage. If there is any damage, please contact our company immediately;

2. The outer shell of the box must be effectively grounded for safe use;

3. The incubator should be placed indoors with good ventilation conditions, and flammable and explosive materials should not be placed around it

4. The incubator does not have explosion-proof devices and cannot contain flammable and explosive materials;

5. Do not place items inside the box too tightly or too heavy, and leave space around to facilitate the circulation of hot air and prevent damage to the shelves;

6. The inside and outside of the incubator should be kept clean regularly. If not in use, the water in the water jacket should be drained, and neutral grease or Vaseline should be applied to the plated parts to prevent corrosion. A plastic dust cover should be placed outside the incubator, and the incubator should be placed in a dry room to prevent damage to the temperature controller caused by moisture;

During the cultivation process, if the relative humidity inside the box is found to be insufficient, a water tray can be placed and allowed to evaporate naturally, usually reaching around 90% RH;

When the ambient temperature is high in summer and the set temperature is below 40 ℃, "air conditioning" should be used to lower the ambient temperature and maintain it between (25-28) ℃ (this temperature must be maintained at night) to avoid causing temperature control and static deviation.