In stock Bucher solenoid valve W2P32SN pressure 315bar

In stock Bucher solenoid valve W2P32SN pressure 315bar 2/2- . The 4/4-way valve seat is driven by a manual lever and can be operated directly

Pressure balanced flange valve, hole type NG6, compliant with ISO 4401-03-02The valve mainly consists of a flange valve body and a built-in 2/2 or 3/2-way seat valve. 3/2 seated valve core (W1... type). Depending on the position of the switch, the connection is either sealed off or flow can pass through from both sides. In the positive direction (W2P...), a blocking switching position can be achieved, that is, during the switching period, there is no connection between the two ends. During the switching process, there were no connections between the connection points. Therefore, only a small amount of switch oil loss will occur. The handle can rotate 360 ° and has a 'locking' type to choose from (W2... T/U/V...) or 'unlocked' (W2... W/X/Y...). In applications where check valves or orifice plates are required at the connection point P, these components can be installed as an option. These lift valves are mainly used in mobile and fixed applications that require tight closure functions such as leak free load holding, tensioning, and clamping.

In these applications, the leak free maintenance, tensioning, and clamping of the load are of decisive importance. The flange body has undergone phosphating treatment. The flange body has undergone phosphating treatment. All zinc nickel coatings.

Zinc nickel coatings according to DIN EN ISO 19 598 standard, which means they can also be used under harsh external conditions. Used under external conditions.

Bucher solenoid valve W2P32SN一般特性：

Name: 2/2-, 3/2-, 3/3-, 4/3- or 4/4-way seat valve

Design flange design, double seat seal, direct operation

Plug/piston design (pressure balance)

Equipped with negative or positive pressure overlap switch

Tightening type 4-hole ∅ 5.5, used for M5x30 hexagon socket bolts

Tightening torque 5.2 Nm ± 5% (4 ft lbs ± 5%)

Connection size NG6, hole type ISO 4401-03-02/form A6, DIN 24 340

Weight 1.45 kg (2/2-... 3/2 direction)

1.90 kg (3/3-... 4/4 way)

Installation location is arbitrary

Hydraulic parameter names, values, and units

Maximum work pressure 315 bar (... 4500 pounds per square inch)

Maximum flow rate of 40 liters per minute (10 gallons per minute)

Precautions for use:

In stock Bucher solenoid valve W2P32SNThe pressure is 315 bar. To prevent uncontrolled pressure reactions or oil backflow, the W2N.../W2P... series directional seat valves can be equipped with plug-in check valves (RCA-5 type) and special valve bodies. (RCA-5 type) and special valve body. Check valves allow free flow from P to A or B and close P without oil leakage. Application: For example, when several valves are connected in parallel, the inlet pressure P is lower than the user pressure A or B (idle circuit or other users with lower activation pressure). In this case, a pressure reducing valve (A or B) can be used to lower the inlet pressure. During this switching operation, the pressure on the user side with higher pressure will not decrease.