portable ultrasonic water depth sensorShallow water alarm setting
The shallow water alarm setting range of this handheld ultrasonic water depth meter is 3-200 feet (1-60.7 meters). When the measured water depth is shallower than the set value, the host will
Sound an alarm.
portable ultrasonic water depth sensorShallow water alarm setting steps:
1. Press the "↑" key once, and the current shallow water alarm setting value will be displayed on the screen. "000" is the default setting at the factory
2. You can press the "↑" key to increase the setting value, and press the "↓" key to decrease the setting value
During the setup process, every time you press the arrow key, the set value changes by 0.3M (1FT). If you hold down the arrow key, the set value will automatically change continuously
3. After selecting the setting value, if no key is pressed for 5 seconds, the system will save your setting value and automatically return to the measurement state
When the screen displays the "bell" and "▲" icons
When the water depth of the tested area is shallower than the set value, the host will emit a continuous 10 second alarm sound, and the panel will display the "bell" and "▼"
The icons flash together, and the alarm sound will turn off after 10 seconds. The panel indicator light and the "bell" and "▲" icons on the screen will continue to flash until they are detected
The measured water depth exceeds the alarm setting value or the shallow water alarm value is reset.
portable ultrasonic water depth sensorDeepwater alarm setting
The deepwater alarm setting range of this handheld ultrasonic depth meter is 3-200 feet (1-60.7 meters). When the water depth in the measured area exceeds the set value, the host will
Sound an alarm.
portable ultrasonic water depth sensorDeep water alarm setting steps:
1. Press the "↓" key once, and the current deepwater alarm setting value will be displayed on the screen. "000" is the default factory setting
2. You can press the "↑" key to increase the setting value, and press the "↓" key to decrease the setting value
During the setup process, every time you press the arrow key, the set value changes by 0.3M (1FT). If you hold down the arrow key, the set value will automatically change continuously
3. After selecting the setting value, if no key is pressed for 5 seconds, the system will save your setting value and automatically return to the measurement state
When the screen displays the "bell" and "▼" icons
4. When the water in the tested area is deeper than the set value, the host will emit a continuous 10 second alarm sound, and the panel will display the "bell" and "▼"
The icons flash together, and after 10 seconds, the alarm sound will turn off, while the panel indicator light and the "bell" and "▼" icons on the screen will continue to flash continuously
When the measured water depth is less than the alarm setting value or the deep water alarm value is reset.
