Where is the professional place for repairing Rexroth tightening controllers with German doctors in Shanghai

NegotiableUpdate on 12/14

Model

Nature of the Manufacturer: Producers

Product Category

Place of Origin

Online Consult

Overview

Common faults in the maintenance of Shanghai Yangon Electronics Rexroth tightening controller: no display when powered on, power light not on, overcurrent, overvoltage, undervoltage, overheating, overload, overspeed, phase loss, jitter, encoder abnormality, module damage, grounding fault, etc. The servo drive is free to inspect, and the repair price is quoted first. After confirmation by the user, repairs can be carried out. Adequate spare parts and fast delivery. All repaired servo drives undergo motor testing to ensure that all functions of the drives are intact. quality assurance

Product Details

Where is the professional place for repairing Rexroth tightening controllers with German doctors in Shanghai

Firstly, the connection between the sensor and the controller should be carefully checked to ensure a secure connection without any looseness or disconnection issues. At the same time, attention should be paid to whether the connecting wires are damaged or aged. Secondly, it is necessary to observe whether the sensor itself has physical damage, such as breakage or deformation, and to detect whether its output signal is normal through professional tools or equipment. Finally, it is also necessary to check if there are any other error messages displayed on the controller panel and ensure that the controller itself is in normal working condition. Through these steps of troubleshooting, we can more accurately identify and solve the problem of the RexrOTH servo tightening axis controller malfunction.

Dr. Rexroth Tightening Controller RepairUnable to start or communicate: This may be due to power issues, communication line faults, or damage to the internal circuit board of Bosch Rexroth tightening wrench controller CS351S-G.

Inaccurate tightening torque: It may be due to sensor malfunction, improper calibration, or incorrect parameter settings of Bosch Rexroth tightening wrench controller CS351S-G.

Overheating or overload alarm: This may be caused by mechanical component wear, poor heat dissipation, or triggering of protective circuits

Where is the professional place for repairing Rexroth tightening controllers with German doctors in ShanghaiTry reconnecting the sensor. If the connection is not secure or the cable is damaged, repair or replace it immediately. Secondly, if there is a malfunction in the sensor itself, such as physical damage or abnormal output signals, it is necessary to replace the sensor with a new one in a timely manner. In addition, it is necessary to check and repair issues with the Rexroth tightening shaft controller itself, such as display errors or communication failures with sensors.