Vertical high-pressure steam sterilization pot laboratory high-temperature disinfection pot

Product Introduction

The high-pressure steam sterilizer consists of a sterilization chamber, a control systemOvervoltage protectionComponents such as devices. The use of high-temperature saturated steam can denature microbial proteins and cause microbial death within a certain period of time, achieving the purpose of sterilizing moisture and heat resistant items.

Due to being in a sealed environmentsteamerThe internal steam cannot overflow, and as the pressure continues to rise, the boiling point of water will also increase, resulting in an increase in the temperature inside the pot. At a pressure of 0.1 MPa, the temperature inside the pot can reach 121 ℃. At this steam temperature, various bacteria can be quickly killed.

Operation steps:

1. First, remove the inner sterilization bucket, and then add an appropriate amount of water to the outer pot to make the water surface level with the triangular shelf.

2. Put it back into the sterilization bucket and fill it with the items to be sterilized. Be careful not to pack it too tightly to avoid obstructing steam flow and affecting sterilization effectiveness.

3. Cover and insert the covered exhaust hose into the exhaust slot of the inner sterilization bucket. Tighten the two opposite bolts symmetrically in pairs to ensure consistent tightness and prevent air leakage.

4. Turn on the power to heat up and turn it on at the same timeexhaust valveBoil the water to expel the cold air from the pot. Waiting for cold airalmostAfter exhausting, close the exhaust valve and let the temperature inside the pot gradually rise with the increase of steam pressure. When the pressure inside the pot reaches the desired level, control the heat source and maintain the pressure for the required time.

5. After the sterilization time is up, cut off the power or turn off the gas to allow the temperature inside the sterilization pot to naturally decrease. When the pressure on the pressure gauge drops to 0, open the exhaust valve, loosen the bolt, open the lid, and remove the sterilized item.

Product details: