Temperature vibration integrated composite sensor

NegotiableUpdate on 05/06

Model

Nature of the Manufacturer: Producers

Product Category

Place of Origin

Online Consult

Overview

The temperature vibration integrated composite sensor has a high installation resonance frequency and a wide range of operating frequencies. The accelerometer adopts a fully stainless steel housing and a fully welded airtight structure, so it can be used in humid and corrosive environments.

Product Details

Temperature vibration integrated composite sensor

Model: DC352　

characteristic:

l isolationIEPEVoltage output,Low noise, strong anti-interference ability

l Simultaneously measure temperature and acceleration values

l Mining explosion-proof and intrinsic safety type

Temperature vibration integrated composite sensorMain technical indicators:

Acceleration sensor section
sensitivity（±5%）	100mV/g
measurement range	±50g
Frequency range (±)5%）	1～10,000Hz
Frequency range (±)10%）	0.6～12，000Hz
Frequency range (±)3dB）	0.4～13，000Hz
resonant frequency	30KHz
Resolution（1～10,000Hz)	400ug
Nonlinear amplitude	≤1%
Maximum lateral sensitivity	≤5%
Impact limit (without power supply)	5000g pk
Operating Temperature	-40～120℃
temperature response	Refer to the attached temperature curve
protection level	IP67
motivationvoltage	18VDC～28VDC(Constant current source))
motivationcurrent	2～10mA
Output impedance	＜100Ω
bias voltage	12±2VDC
noise	＜50MV
sensitivematerial	PZT-5
structuredesign	cut
Temperature sensor section
Temperature sensitive components	PT1000
weight	≈ 75gm
Overall dimensions	φ22×52mm
Install ground insulation	≥10⁹Ω
Installationthread	1/4-28 UNF
installation torque	2.7～6.8N·m
housingmaterial	304stainless steel
sealing form	Welding seal
Base strain sensitivity	0.2mg/with
output method	top5/8-24，3core,MIL-C-5015 1:ICP+；2:COM3；3:Tout

Sensor installation

1）Select sensors based on the measurement range of the measuring part, the environment and size of the installation space, and the characteristics of the measured material, and check whether the appearance of each part of the sensor is intact and whether each part is compatible; Usually, sensors ordered in sets are provided with a calibration card at the factory, which indicates the model and number of the sensor being calibrated. This can be used to check the markings on the product and then make specific markings on the sensor probe (such as“1#To illustrate its function and distinguish the connection relationship between various parts of multiple sets of sensors, such as "horizontal vibration of tiles" and "axial displacement", both ends of the cable should be marked for identification among multiple cable heads. This marking should be oil and waterproof.