- Phone
-
Address
2nd Floor, No. 50 Dongfanghuigu, Lane 2999, Bao'an Road, Jiading District, Shanghai
Product Categories
Shanghai Naichuang Testing Technology Co., Ltd
Shanghai Naichuang ForceChina Single Force Platform Force Sensor
NegotiableUpdate on 05/06
- Model
- Nature of the Manufacturer
- Producers
- Product Category
- Place of Origin
Overview
Shanghai Naichuang ForceChina Single Force Platform Force Sensor Model: FC1G130-R-FX Instructions for Use The balance should be preheated for 40 minutes before use; $r $n (2) During use, it should be dust-proof, moisture-proof, oil proof, and avoid severe vibration. It is strictly prohibited to touch the strain gauge; $r $n (3) It is strictly prohibited to strike, and overloading is not allowed without safety verification calculations; The unit of each output voltage reading in the $r $n (4) balance calibration formula is mV/V, Δ ni=ni-ni0 (where ni is the blowing reading and ni0 is the initial reading), i=FX，MY，MZ
Product Details
Shanghai Naichuang ForceChina Single Force Platform Force Sensor
Model: FC1G130-R-FX
Instructions for using the balance
1. Measure component information
FX |
MY |
MZ |
|
Design load FS (N) |
100 |
/ |
/ |
Calibration load (kg) |
9.6 |
/ |
/ |
Comprehensive loading repeatability (% FS) |
0.05 |
/ |
/ |
Comprehensive loading error (% FS) |
0.1 |
/ |
/ |
2. Bridge Road Information
Bridge code |
B1 |
B2 |
B3 |
|
Bridge arm resistance (Ω) |
350 |
350 |
350 |
|
Outer lead number |
Power supply+ |
red |
||
Power supply- |
black |
|||
Signal+ |
Yellow: X1+ |
Blue: X2+ |
Green: MZ+ |
|
Signal- |
Yellow: X1- |
Blue: X2- |
Green: MZ- |
|
Rated voltage (V) |
10 |
|||
Maximum voltage (V) |
15 |
|||
Shanghai Naichuang ForceChina Single Force Platform Force Sensor
3. Instructions for using a single force balance
(1) The balance should be preheated for 40 minutes before use;
(2) During use, it should be dust-proof, moisture-proof, oil proof, and avoid severe vibration. It is strictly prohibited to touch the strain gauges;
(3) It is strictly prohibited to strike, and overloading is not allowed without safety verification calculations;
(4) The unit of each output voltage reading in the balance calibration formula is mV/V, Δ ni=ni-ni0 (where ni is the blowing reading and ni0 is the initial reading), i=FX，MY，MZ);
(5) The load unit calculated by the balance calibration formula is kg or kg · m. When converting to N or N · m, it should be multiplied by 9.80665m/s ²;
(6) Supply power according to the rated bridge voltage, otherwise measurement data correction should be carried out;
(7) The formula for calculating the balance load is in an iterative form.
Similar Product Recommend
