Seamless safety sliding contact wire manufacturer

The seamless safety sliding contact wire manufacturer uses 99% oxygen free copper to deliver power, with low voltage drop and excellent conductivity. A safety rail of the same length can be matched according to the length of the user's workshop or the user's needs, so that there is no interface in the safety distribution of the entire workshop, truly solving the problem of short circuits or inability to operate caused by frequent jamming of the collector due to multiple interfaces in domestic sliding wires.

Seamless safety sliding contact wire manufacturerTransporting power with 99% oxygen free copper, low voltage drop, and excellent conductivity. A safety rail of the same length can be matched according to the length of the user's workshop or the user's needs, so that there is no interface in the safety distribution of the entire workshop, truly solving the problem of short circuits or inability to operate caused by frequent jamming of the collector due to multiple interfaces in domestic sliding wires. And it is suitable for the design of curves, arcs, and high-low walking. So as to make the entire overhead crane project beautiful, tidy, and safe. Suitable for: crane systems, automatic storage, amusement park power supply, production testing systems.

Seamless safety sliding contact wire manufacturerHFCE305 safety rail 3P160A seamless plate sliding contact wire Yangzhou Tianxiang Electric seamless sliding contact wire features:

1. The conductor is oxygen free copper, with excellent conductivity, pure quality, and uniform color and bright surface

2. The crane runs smoothly, the collector travels without noise, and there is no poor contact due to vibration, ensuring good contact*

3. The insulation material is PVC+impact resistant, UV resistant, specially formulated, with excellent physical properties

4. No connector, low pressure drop

5. Less parts, the electric rail is clamped in, easy to install, and installation time can be saved by 2/3

6. Collector frame arm length, equipped with independent tension spring, large movable arc

7. Compared with traditional multi pole tube sliding lines, there is no damage during installation and transportation, and transportation costs are reduced

8. The price is cheaper compared to tubular sliding contact wires at the same cross-section

The shell of the bus duct is generally formed by bending steel plates or using simple aluminum alloy profiles. Due to the lack of certain waterproof measures for these two types of shells, water is easily immersed in the bus duct during fire extinguishing or when it is exposed to rain, causing a short circuit and resulting in a generally low waterproof level of the entire product, and the product quality cannot be guaranteed. The overlap size of busbar duct accessory joints shall be made by drilling holes with a drill according to the regulations. When bending the bus duct, first make a large sample, and then perform cold bending according to the size of the large sample. There should be no cracks or significant wrinkles at the bending point of the busbar. The distance between the bending point of the busbar and the connection point should not be less than 50mm. The bending degree of multiple busbars should be consistent, and the small bending radius should comply with the specifications. After the busbar is processed, it should be painted with phase paint, but phase paint should not be painted in the following areas: bolt connections and support connections of the busbar, connections between the busbar and electrical appliances, and areas within 10mm of all connections. Polish the busbar joint with sandpaper, remove the oxide layer, tin it, apply electrical composite grease, and protect it for installation.