SPC3200LW High Temperature Resistant Triangle Belt SPC3200LW Belt

SPC type imported triangle belt

Triangle belt maintenance method:

Loading and unloading of belts. Before installation, first check whether the driving wheel, driven wheel, and tensioning wheel are on the same plane. Generally speaking, when the center distance between two pulleys is less than 1 meter, the allowable deviation is 2-3 millimeters, and when the center distance is greater than 1 meter, the allowable deviation is 3-4 millimeters. If the deviation is too large, it should be adjusted to meet the requirements before installation and tensioning. When loading and unloading, the tensioner should be loosened first, or the infinitely variable speed end disc should be removed first, and the belt should be installed or removed. When the new V-belt is too tight and difficult to install and remove, the pulley should be removed first, and then the V-belt should be fitted or removed before installing the pulley. Hard removal is not allowed. Generally, the V-belt should be disassembled and installed after removing the pulley. The tension of the belt. The tension of the transmission belt is adjusted by the tensioning wheel. If the belt is too tight, it will cause serious wear and tear, and if it is too loose, it is easy to slip, causing serious wear and even burning of the V-belt. When the distance between two wheels is about 1 meter, press the middle of the triangle belt with your fingers and it should descend vertically by 10-20 millimeters. During use, the tension of the V-belt should be checked and adjusted at any time. Belt replacement. After the effectiveness of the V-belt, it should be replaced in a timely manner. If multiple V-belts are used together, if one or part of them are ineffective, the other ones should be replaced at the same time, and new and old belts should not be used together. Cleaning of the belt. When the V-belt is stained with grease, engine oil and other oil stains, it is easy to slip and accelerate the damage of the V-belt. It should be cleaned with gasoline or alkaline water in a timely manner, and cannot be operated with oil. The working temperature of the belt.

SPC type imported triangle belt

Ozone resistance characteristics

The ozone resistance of a belt is its ability to resist chemical corrosion in an ozone environment, as ozone can cause chemical bonding and decomposition, and the failure mode is cracking. The degradation of rubber mainly depends on the concentration of ozone and the frequency of exposure. When the belt is compressed, the degradation of rubber caused by ozone will increase. In theory, belts with larger cross-sections suffer more degradation than those with smaller cross-sections when bent on a pulley, represented as good and very good in the table below.

SPC type imported triangle belt

Industrial belts such as Samsung and Hankou from Japan, Gates from the United States, and Obi from Germany, as well as transmission belts, V-belts, synchronous belts, wide-angle belts, and various other special industrial belts, PTFE mesh belts, PVC conveyor belts, PTFE coatings, NAK and TTO oil seals, and high-strength boltsOriginal importedSPC type imported triangle belt

SPC3200LW High Temperature Resistant Triangle Belt SPC3200LW Belt

SPC3200LW High Temperature Resistant Triangle Belt SPC3200LW Belt