Rohde&Schwarz SMW200A Vector Signal Generator

Rohde&Schwarz SMW200A Vector Signal GeneratorKey Features:
Meet all your requirements
The frequency range is between 100 kHz and 3 GHz, 6 GHz, 12.75 GHz, 20 GHz, 31.8 GHz, or 40 GHz
Optional additional RF paths (100 kHz to 3 GHz, 6 GHz, 12.75 GHz, or 20 GHz)
General configuration: From single channel to multi-channel MIMO receiver tester
Featuring up to eight signal sources and up to 32 fading channels, it is highly suitable for MIMO, MSR, or LTE Advanced applications
Adopting a modular architecture to better adapt to the applications at hand
Rohde&Schwarz SMW200A Vector Signal GeneratorSimplify settings
Easily generate complex signals
On two internal baseband modules with real-time encoders and ARBs, there can be up to eight baseband generators
Internal numbers increase the baseband signal, even if there are frequency and level offsets
Integrated broadband baseband and vector signal generator
Support all important digital standards, such as 5G candidate air interface, LTE (12th edition), 3GPP FDD/HSPA/HSPA+, GSM/EDGE/EDGE Evolution, and CDMA 2000 ®/ 1xEV-DO、WLAN IEEE 802.11a/b/g/n/j/p/ac/ad
No need for separate PC software that meets digital standards
Generate radar signal scenarios suitable for module, receiver, and DFS testing
LTE and 3GPP Test Case Wizard for easy base station consistency testing based on 3GPP TS 25.141 or 3GPP TS 36.141
Envelope tracking and AM/AM, AM/φ M pre distortion options for fully testing and verifying ET modulator chipsets

Bringing Reality to the Laboratory
Optional integrated fading simulator for channel simulation at a bandwidth of 160 MHz
All important fading scenarios have been pre-set
Install up to four fading modules and provide up to 32 'logical' attenuators
Implement all important MIMO fading scenarios using a single instrument, such as 2x2, 3x3, 4x4, 8x4, and 4x8
Support complex applications such as dual carrier HSPA, LTE carrier aggregation, MIMO, and multi-user LTE
Connect R&S ® SGT100A signal generator module, providing up to eight RF channels
optimize equipment
The signal quality helps ensure high accuracy in spectrum and modulation measurements
Internal baseband 2 GHz I/Q modulation bandwidth (RF bandwidth)
Within a 2 GHz bandwidth, the modulation frequency response is<0.4 dB (measured value)
Pulse modulation, switch ratio>80 dB, and rise/fall time
Spectral purity (SSB phase noise is typically -139 dBc at 1 GHz, 20 kHz bias)
Phase coherence options, such as for beamforming applications
3 GHz, 6 GHz, and 12.75 GHz RF channels (with electronic attenuators)
Accelerate development
Intuitive operation concepts and intelligent help functions help users achieve success quickly
Key operational element diagram, visually presenting signal flow
Adaptive GUI provides an overview of both simple and complex scenes
Graphic signal monitoring, covering almost every point in the signal flow
Provide context related to the online help system for complete user files
SCPI macro recorder and code generator, used to generate executable remote control code through manual operation steps (e.g. for MATLAB) ®、 CVI, etc.)
Continuously improve according to your needs
Instrument customization to adapt to almost all applications
An excellent plug-in system that facilitates the modification of baseband modules without the need for recalibration of instruments
Software upgrades can be performed at any time, simply activate quickly through a key sheet