REMS high-speed steel circular saw blade 849704 R supplied by Yarns

REMS 849704 R is a carbon steel special original saw blade for Turbo series pipe cutting machines, with high toughness, efficient cutting, and low burrs as its core advantages. It is designed for dry cutting of carbon steel/galvanized steel pipes and is an accessory for carbon steel pipeline construction such as plumbing, gas, and fire protection

REMS high-speed steel circular saw blade 849704 RMaterial and structural highlights

HSS gear for carbon steel

The teeth have undergone special hardening treatment, with a hardness of HRC 62-64 and better toughness than stainless steel special saw blades. When cutting carbon steel, they are less prone to tooth breakage and have strong impact resistance, making them suitable for cutting thick walled carbon steel.

160 tooth medium fine tooth design

The tooth density is adapted to the characteristics of carbon steel, with high cutting efficiency, good cutting perpendicularity, controllable burrs, reduced secondary polishing processes, and a balance between batch construction and precision requirements.

Accurately adapting to the substrate

32mm standard aperture matched with Turbo series host flange, high-speed rotation without shaking; The substrate undergoes stress relief treatment to resist bending and fracture, ensuring safe continuous operation.

Anti adhesive coating

Surface specific coating reduces carbon steel chip adhesion, lowers the risk of tooth overheating, improves chip removal efficiency, and avoids pipe erosion and incision deformation

REMS high-speed steel circular saw blade 849704 RAdaptation and replacement points

1. Confirmation of compatible models

Priority for Turbo Cu INOX (849006 R110) and Turbo K series circular saw machines.

Please use 849703 R (220 tooth HSS) for cutting stainless steel/copper; Cutting thick walled carbon steel can upgrade to 849706 R (HSS-E).

2. Replacement and installation

Turn off the power and remove the main unit, then open the saw blade protective cover.

Loosen the spindle nut with a special wrench and remove the old saw blade.

Align the new saw blade with a 32mm aperture, ensuring that the tooth tip direction is consistent with the rotation direction of the main engine.

After tightening the nut, run it idle for 10-15 seconds to check for any shaking. Once confirmed, use it again.

3. Timing of replacement

The cutting speed significantly decreases and burrs significantly increase;

The teeth have cracks and severe wear;

The saw blade substrate is deformed or cracked (stop immediately to avoid safety risks).

REMS high-speed steel circular saw blade commonly used models:

TURBO circular saw blade (compatible with electric pipe cutting machine)

849703 R (copper/stainless steel/non-ferrous metals)

849704 R (specifically for carbon steel)

849705 R (for thick walled stainless steel)

REMS circular saw blade HSS 225 x 2 x 32 mm, 220 teeth

Art. no. 849703 R

REMS circular saw blade HSS-E 225 x2 x32 mm, 220 teeth

Art. no. 849706 R