REMS high-speed steel circular saw blade 849703 R, original from Germany

REMS 849703 R is a German original HSS high-speed steel circular saw blade designed specifically for the REMS Turbo series electric pipe cutting machine. It specializes in dry low burr precision cutting of thin-walled metals such as stainless steel and copper, and is compatible with Turbo Cu-INOX and Turbo K models. It is a standard accessory for the construction of plumbing, gas, and crimping systems

REMS high-speed steel circular saw blade 849703 RMaterial and structural highlights

HSS high-speed steel teeth

The teeth have undergone quenching and hardening treatment, with a hardness of HRC 63-65, wear-resistant and impact resistant, suitable for long-term dry cutting of stainless steel and copper pipes.

220 tooth fine tooth design

High density of fine teeth, smooth cutting surface, minimal burrs, no need for secondary trimming, suitable for the sealing surface requirements of pressure joint pipeline systems.

Accurate aperture and substrate

The aperture is 32mm, matched with the main flange, and rotates at high speed without shaking; The substrate undergoes stress relief treatment to resist bending and fracture, ensuring safe continuous operation.

Low viscosity coating

The special coating on the surface reduces chip adhesion, lowers the risk of tooth overheating, and improves chip removal efficiency to avoid pipe erosion and deformation.

REMS high-speed steel circular saw blade 849703 Rcore advantage

Low burrs and high precision

Fine tooth+dry cutting, with good perpendicularity of the incision and extremely light burrs, meets the requirements of crimping and sealing installation, and reduces subsequent polishing processes.

Efficient and durable

The 220 tooth fine tooth design has high cutting efficiency, and the HSS material is wear-resistant, significantly improving the lifespan compared to ordinary saw blades, making it suitable for batch application.

Factory adaptation

Specially designed for Turbo series models, with high installation accuracy to avoid cutting deviation and equipment damage caused by saw blade shaking.

Eco-friendly and convenient

Dry cutting does not require coolant, on-site cleaning, no waste liquid treatment, suitable for multi scene operations in construction sites and workshops

REMS high-speed steel circular saw blade 849703 RAdaptation and replacement points

1. Confirmation of compatible models

Priority for Turbo Cu INOX (849006 R110) and Turbo K series circular saw machines.

If higher hardness and lifespan are required, you can upgrade to choose the same specification saw blade made of HSS-E material (material number should be based on the original factory) REMS GmbH&Co KG.

2. Replacement and installation

Turn off the power and remove the main unit, then open the saw blade protective cover.

Loosen the spindle nut with a special wrench and remove the old saw blade.

Align the new saw blade with a 32mm aperture, install it flat, and ensure that the tooth tip direction is correct (consistent with the rotation direction).

After tightening the nut, run it idle for 10-15 seconds to check for any shaking. Once confirmed, use it again.

3. Timing of replacement

The cutting speed significantly decreases and burrs increase;

The teeth have cracks and severe wear;

The saw blade substrate is deformed or cracked (stop immediately to avoid safety risks).

REMS high-speed steel circular saw blade commonly used models:

TURBO circular saw blade (compatible with electric pipe cutting machine)

849703 R (copper/stainless steel/non-ferrous metals)

849704 R (specifically for carbon steel)

849705 R (for thick walled stainless steel)

REMS circular saw blade HSS 225 x 2 x 32 mm, 220 teeth

Art. no. 849703 R

REMS circular saw blade HSS-E 225 x2 x32 mm, 220 teeth

Art. no. 849706 R