-
E-mail
eric@sdicelc.com
-
Phone
18911571363
-
Address
15th Floor, Building 6, Courtyard 2, Wuliqiao Second Street, Chaoyang District, Beijing
Beijing Zhongqing Guotou Environmental Protection Technology Co., Ltd
eric@sdicelc.com
18911571363
15th Floor, Building 6, Courtyard 2, Wuliqiao Second Street, Chaoyang District, Beijing
-NPW-160 Total Phosphorus/Total Nitrogen Two in One Online Analyzerworking principle:
Total phosphorus determination (in accordance with international GB11893-89): Potassium persulfate is added to the sample as an oxidant, and the water sample to be tested is dissolved at 120 ℃ for 30 minutes to convert phosphides into phosphate ions. The total phosphorus content of the water is detected by molybdenum blue spectrophotometry (measurement wavelength: 700nm).
Total nitrogen determination (in accordance with international GB11893-89): Potassium persulfate is used as an oxidant to dissolve at 120 ℃ for 30 minutes, converting nitrides into nitrate ions. The pH of the sample solution is adjusted to 2-3, and the total nitrogen content in the water is detected by UV spectrophotometry (measurement wavelength: 220nm, 275nm turbidity correction: A=A220-A275 × 2).
COD (UV) determination: Dual wavelength spectrophotometry (UV 254nm, visible 546nm).
-Application industry:
The NPW-160 total phosphorus/total nitrogen analyzer is mainly used for automatic monitoring of total phosphorus, total nitrogen, and COD in surface water, tap water, municipal sewage, or other special occasions.
-NPW-160 Total Phosphorus/Total Nitrogen Two in One Online AnalyzerInstrument features:
The NPW-160 total phosphorus/total nitrogen analyzer is equipped with a multi wavelength detector, which can measure three indicators: total phosphorus, total nitrogen, and COD (UV).
The independently designed heating and decomposition device realizes the integrated design of digestion measurement in the total phosphorus/total nitrogen analyzer system, simplifying pipeline connections.
The NPW-160 total phosphorus/total nitrogen analyzer has a built-in CF card, and the data can be stored for a long time.
The reading is fast and accurate, and it can be equipped with wireless transmission function, which is intelligent and reliable.
Low reagent consumption and waste liquid discharge, low operation and maintenance costs, and minimal secondary pollution. .
| NPW-160 Total Phosphorus/Total Nitrogen Two in One Online AnalyzerTECHNICAL INDEX | |
|---|---|
| Measurement range: | Total nitrogen, 0-2mg/L to 200mg/L |
| Total phosphorus, 0-0.5mg/L to 20mg/L | |
| Repeatability: | ≤± 3% FS |
| Analysis interval: | 1 hour to 6 hours, can be set arbitrarily |
| Sample conditions: | Temperature, 2-40 ℃ |
| Pressure, 0.02-0.05MPa | |
| Flow rate, 1-3 L/min | |
| The sample size for each analysis is approximately 67.5mL | |
| Reagent replenishment interval: | 1 month |
| Work environment: | Temperature: 2-40 ℃, 85% relative humidity, indoor installation |
| Analog output: | 4~20 mA, Load 600 ohm |
| relay: | Can set upper and lower limit alarms, fault information, etc |
| Power Supply: | 220VAC,50/60HZ |
| power waste: | 500VA (maximum) 200VA (average) |
| Data communication: | RS485 serial port |
| External dimensions: | 450 × 380 × 1430 mm |
| Weight: | About 80Kg |
| ordering guide | |
|---|---|
| The standard configuration includes: host, operation manual, installation accessories, etc. | |
| NPW160-0-2C11EA000A001 | |
| Total phosphorus: | 0~0.5mg/L (factory setting) |
| Total nitrogen: | 0~20mg/L (factory setting) |
| 20mm detection tank, suitable for surface water, tap water, and municipal sewage discharge outlets that meet discharge standards | |
| NPW160-0-2C11GE000A001 | |
| Total phosphorus: | 0~10mg/L (factory setting) |
| Total nitrogen: | 0~50mg/L (factory setting) |
| 10mm detection tank, suitable for the sewage industry | |
| NPW160-0-2C11HF000A001 | |
| Total phosphorus: | 0~20mg/L (factory setting) |
| Total nitrogen: | 0~100mg/L (factory setting) |
| 5mm detection cell, suitable for special occasions | |