Multi point magnetic heating stirrer

Technical parameters of multi-point heating magnetic stirrer:

Digital ten point magnetic stirrer, stirring at ten points;

• Power supply: 220V/50Hz (can make mouth type 110V/60Hz);
  Panel material: square aluminum alloy panel+ceramic anti-corrosion coating;
  Temperature control range: Room temperature 350 ℃;
  Temperature control accuracy: ± 1 ℃;
  The internal and external sensors can alternately measure and control the temperature of the solution;
  Working size: 450 * 200mm;
  Mixing capacity: 0-500ml x 10;
  Speed range: 50-2000 revolutions per minute;
  It can be mixed synchronously at multiple points or separately at a single point;

Multi point heating magnetic stirrer product features:

1.Multi point magnetic heating stirrer5 o'clock, 10 o'clock.

2. Multiple points can be mixed synchronously, or a single point can be mixed separately.

3. Digital speed display function.

4. Adopting a DC brushless speed regulating motor, it has stable performance, low noise, long service life, and no spark generation.

5. The ceramic heating surface is used for heating, which is aesthetically pleasing, corrosion-resistant, and does not deform when heated.

The maximum surface temperature can reach 350 ℃.

7. The temperature control adopts fuzzy PID control algorithm, dual screen digital display, self-tuning function, with high measurement accuracy, small temperature surge, single key touch operation, internal and external thermocouple temperature measurement, thyristor control output, 160-240V wide voltage power supply, and has a break protection function.

8. It can heat and stir standard or non-standard reaction bottles, non-magnetic metal or other non-metallic containers ranging from 50-500ml

9. The shell adopts a one-time flame retardant reinforced PBT injection molded shell, which is heat-resistant, corrosion-resistant, and has good insulation performance.

10. Equipped with over temperature protection function.

The 11.30 ° inclined control panel is suitable for both sitting and standing perspectives.

Precautions for using multi-point magnetic heating magnetic stirrer:

1. Do not dry burn for use.

2. The instrument should have a good grounding.

3. During the first use, white smoke and odor may appear inside the board, which is a normal phenomenon. Due to the presence of oil and other compounds in the internal insulation material during production, it should be placed in a well ventilated area and can be used normally after a few minutes of disappearance.

4. Due to the limited temperature resistance of the motor and magnet of the mixer, especially during high-temperature heating tests, the instrument cannot be used solely for heating. Please adjust the motor to rotate or rotate at low speed (idle) to prevent damage to the motor, magnet, and high-temperature radiation.

When the high-temperature heating is completed, please turn off the heating first and wait for a few minutes for the remaining temperature to dissipate before turning off the stirring.

6. The heating part has a high temperature, so be careful when working to avoid burns.

7. When wet hands, liquid overflow, or long-term exposure to high humidity, there may be induced electricity transmitted through the insulation layer to the outer shell. Please ground the wire and pay attention to ventilation. If the leakage is severe, please do not use it again. It should be dried in the sun or in an oven before use to avoid danger.

If you find that there is no power supply, please first check whether the right rear fuse needs to be replaced.

When not in use for a long time, please keep the instrument clean and store it in a dry and non corrosive gas place.