Hohenzollern tension sensor

Hohenzollern tension sensor

Radial tension sensor series, model RFS 200.

Axial sensor for measuring radial tension.

The online measurement of tension can reach 10kN.

Designed as a single wheel system.

Accurate online tension measurement.

Widely applicable and adaptable to various working conditions.

Install special molds for shaft processing.

• Easy to install.

Durable electroplated steel casing.

7 range options are available.

0-0.5kN. ..0-10kN。

description

RFS 200 can maintain long-lasting online accuracy, long service life, and wide range of measurement.

The introduction point that is not subject to force and the influence of axial lever force.

The principle of tension measurement is based on the radial tension value acting on the bearing being transmitted to the sensor.

This force is determined by the geometric structure of the winding and the magnitude of the tension on the line.

• Not affected by any possible axial tilt torque.

The force directly acts on the shaft.

Hohenzollern tension sensor

This measurement principle enables the sensor to have high sensitivity and excellent performance. The force acting radially on the bearing can produce small changes along the measured vector direction, causing elastic deformation of the load unit. This deformation amount is compared with the corresponding point of the pre recorded deformation standard scale and converted into the corresponding electrical value.

The principle of tension measurement is based on the radial tension value acting on the bearing being transmitted to the sensor, which is determined by the geometric structure of the winding and the magnitude of the tension on the line.

Measurement amplifier:

TS 621。

• Used for standard tension sensors.

• Optional power supply.

DC 24V power supply is required.

• Current isolation.

TS 503

• Used for standard tension sensors.

• Low consumption.

Only 12.5mm wide.

24V DC power supply.

TS 481

• Used for standard tension sensors.

19 "installation board.

Three parallel interfaces.

115/230V AC power supply.

MU 481-19 'Digital/Analog Display

Designed for standard tension sensors.

Single channel operational amplifier.

Digital/analog display.

Desktop casing.

Recommended peripheral options

DPM 502。

LED display, 3 1/2 digital display.

• Free upgrade.

Front panel operation.

24V DC power supply.

Analysis software HCC Easy

• Measurement.

• Storage.

• Analysis.

End open type

Plug and cable connection type.

6-core, 270 °.

Gold plated plug.