Hohenzollern tension sensor

Hohenzollern tension sensor

Model: RFS200S single axis radial tension sensor.

The axial sensor for measuring radial tension can measure tension up to 10 kN online.

Special tension measurement design.

Disk energy storage function.

·Can be applied to different working conditions.

·Install special molds for shaft processing.

·Easy to install.

·Durable electroplated steel casing.

·7 selectable ranges.

0 to 0,5kN . .. 0 to 10kN。

description

RFS 200S can maintain long-lasting online accuracy, long service life, and wide range of measurement.

The introduction point that is not subject to force and the influence of axial lever force.

The principle of tension measurement is based on the radial tension value acting on the bearing being transmitted to the sensor.

This force is determined by the geometric structure of the winding and the magnitude of the tension on the line.

• Not affected by any possible axial tilt torque.

The force directly acts on the shaft.

This measurement principle enables the sensor to have high sensitivity and excellent performance. The force acting radially on the bearing can produce small changes along the measured vector direction, causing elastic deformation of the load unit. This deformation amount is compared with the corresponding point of the pre recorded deformation standard scale and converted into the corresponding electrical value.

The principle of tension measurement is based on the radial tension value acting on the bearing being transmitted to the sensor. This force is determined by the geometric structure of the winding and the magnitude of the tension on the wire.

Hohenzollern tension sensor

Connection type:

End open type.

Plug and cable connection type.

6-core, 270 °.

Gold plated plug.

Measurement amplifier:

TS 621。

• Used for standard tension sensors.

• Optional power supply.

DC 24V power supply is required.

• Current isolation.

TS 503。

• Used for standard tension sensors.

• Low consumption.

Only 12.5mm wide.

24V DC power supply.

TS 481

• Used for standard tension sensors.

19 "installation board.

Three parallel interfaces.

115/230V AC power supply.

MU 481-19 'digital/analog display.

Designed for standard tension sensors.

Single channel operational amplifier.

Digital/analog display.

Desktop casing.

Recommended peripheral options:

Analysis software HCC Easy.

• Measurement.

• Storage.

• Analysis.

DPM 502。

LED display, 3 1/2 digital display.

• Free upgrade.

Front panel operation.

24V DC power supply.