HH-6J Constant Temperature Digital Magnetic Stirring Water Bath Pot

1、 Product Introduction

HH-6J Constant TemperatureDigital magnetic stirring water bathWidely used in drying, concentration, distillation, impregnation of chemical reagents, pharmaceuticals, and biological products, it can also be used for constant temperature heating in water baths and other temperature tests. It is a tool for biology, genetics, aquaculture, environmental protection, medicine, health disciplines, biochemical laboratories, education and scientific research. This product adds magnetic stirring on the basis of a water bath, which has the characteristics of short thermal equilibrium time, low temperature fluctuation, and good uniformity.

IIHH-6J Constant TemperatureDigital magnetic stirring water bathThe main characteristics of

1. The studio water tank is made of high-quality stainless steel material, which has excellent corrosion resistance.

2. Adopting intelligent instrument temperature control and PID control, temperature control is convenient and intuitive, and the accuracy is greatly improved.

3. Accurate temperature control, digital display, and the ability to select a constant temperature at any point within the range of room temperature to 100 ℃ as the operating temperature.

4. According to customer needs, temperature ultra-low temperature alarm function can be added.

5. To ensure accuracy, magnetic speed regulation mixing can also be added according to customer needs to improve uniformity.

6. Easy to operate, safe to use, with minimal temperature fluctuations and good uniformity.

3、 Main parameters of HH-6J

1. Power supply: 220V 50Hz

2. Working size: 470 × 310 × 130mm

3. Heating power: 1500W

4. Mixing power: 6 × 40W

5. Mixing speed: 0-2400 revolutions per minute

6. Temperature fluctuation: ± 0.5 ℃

7. Temperature uniformity: ± 0.5 ℃

4、 Instructions for using HH-6J

1. The water bath should be placed on a fixed platform, and the power supply voltage must match the required voltage of this product. The power socket should use a three hole safety socket and must be equipped with a grounding wire.

2. Before use, the water level should be added to the tank. The water level must be higher than the partition and should not be dry or lower than the insulation board to prevent damage to the heating tube.

3. Connect the power, turn on the power switch, and the indicator light will turn on. You can choose a constant temperature at any point within the range of room temperature to 100 ℃ as the operating temperature. (For detailed temperature setting operations, please refer to the packing list manual)

5、 Precautions for HH-6J

1. When injecting water, do not fill it too full to prevent it from boiling and flowing into the compartment and control box to prevent electric shock. When not in use, drain the water in a timely manner, wipe it clean, and keep it clean to facilitate its service life.

2. The temperature control system is carefully calibrated and equipped with devices. Users cannot adjust the internal components arbitrarily, otherwise it will affect the accuracy.

3. To measure water temperature, it is necessary to wait for a stable state of measurement, otherwise the error will increase.