HH-10 digital constant temperature water bath

1、 Product Introduction

HH-10 digital constant temperature water bathWidely used in drying, concentration, distillation, impregnation of chemical reagents, pharmaceuticals, and biological products, it can also be used for constant temperature heating in water baths and other temperature tests. It is a tool for biology, genetics, aquaculture, environmental protection, medicine, health disciplines, biochemical laboratories, education and scientific research.

IIHH-10 digital constant temperature water bathThe main characteristics of

1. The studio water tank is made of stainless steel material, which has good corrosion resistance.

2. The surface of the box is coated with epoxy powder electrostatic spraying.

3. Adopting intelligent temperature control, precise temperature control, digital display, and automatic temperature control.

4. Adopting advanced electronic technology to improve temperature control accuracy.

5. Easy to operate and safe to use.

3、 Main parameters of HH-10

1. Temperature control range: room temperature -100 ℃

2. Heating power: 2500W

3. Maximum error: ± 0.5 ℃

4. Resolution: 0.1 ℃

5. Working size: 780 × 310 × 130mm

6. Dimensions: 940 × 400 × 200mm

7. Power supply: 220V 50Hz

4、 Instructions for using HH-10

1. The constant temperature water bath should be placed flat on a fixed platform, and the power supply voltage must match the required voltage of the water bath. The power socket should use a three hole safety socket, and the ground wire must be properly connected before use.

2. Before the experiment, according to the experimental requirements, add an appropriate amount of clean water or purified water to the water tank until it reaches the partition or higher. Then place the experimental vessel on the shelf and cover the hole cover.

3. Turn on the power switch, the temperature controller will light up, click the function button, and the last digit will start flashing. Click △ or ▽ to select the working temperature, and then click the function button again to exit. At this time, it will run according to the set parameters. After the experimental work is completed, turn off the power switch, cut off the power supply of the equipment, and drain the water in the sink completely.

5Maintenance and upkeep of HH-10

1. Clean the instrument immediately after each use. Drain the water from the water bath, use a brush to gently remove coarse debris from the water bath, wipe the inner and outer surfaces of the water bath clean with a soft cloth, and then dry with a cleaning cloth.

2. The inner surface of the equipment should be free of water droplets, and the outer surface of the equipment should be bright, clean, and free of stains.

3. When using a water bath, it must be reliably grounded and water must not overflow into the control box.

4. Do not leave water in the water bath or keep the water level below the electric heating tube to prevent it from bursting or damaging.

5. Conduct monthly maintenance checks on the instruments and promptly fill out maintenance records.