Electric hydraulic demoulder manufacturer

YT-30 typeElectric hydraulic demoulder manufacturer*It mainly consists of accessories such as beams, columns, trays, shells, and bases. The crossbeam can be equipped with demolding and component accessories for various trial mold demolding purposes. The center hole of the oil cylinder plunger can be equipped with various accessories for easy demolding and component installation. The tray is used for positioning and supporting the mold barrel during demolding. Main specifications and technical parameters:

1. Drunk heavy load: 300KN

2. Range of force gauge: 0-60Mpa

3. Rising speed: 50c m/min

4. Oil drunk high working pressure: 30Mpa

5. Piston diameter 100 mm

6. Piston drunk large stroke: 280mm

7. Voltage: 380V/50HZ Power: 1100W Rotation speed: 1400 revolutions per minute

8. Dimensions: 600 × 520 × 1260mm (length × width × height)

9. Net weight: 120kg

Electric hydraulic demoulder manufacturer * Precautions:

1. It is strictly prohibited to not refuel and let the oil pump run idle.

2. Before use, the system must be completely emptied of air.

3. When using, the pressure reading should be observed, and it is strictly prohibited to exceed 35Mpa. When approaching

The power should be quickly cut off.

4. When demolding, attention should be paid to the rising distance of the oil cylinder, and it is strictly prohibited for the piston to come into contact with the test mold

To prevent damage to the components, operators should pay special attention.

5. After completing the experiment, the piston should be lowered to the bottom to prevent rusting caused by moisture on the piston.