Detailed informationFT-102Hall current meter/bulk densityMeasuring instrument（
Stainless steel material)FT-102 Hall current meterLiquidity and loose density measurement device
Configure height positioning blocks, level devices, and positioning devices for funnels and measuring cups to ensure that the centers of funnels and measuring cups are in a straight line;This instrument is based onGB 1482-2010-TThe standard funnel method (Hall flowmeter) for determining the flowability of metal powders is used insteadGB1479-84TheGB1482-84Standard specification productionDesign and production according to regulations.
Its detection method and results are universal compared to internationally recognized detection methods. This product is also suitable for measuring the flowability and bulk density of similar powder materials.This device is suitable for measuring using the standard funnel methodThe flowability of metal powderWhat can freely flow through the aperture2.5mmThis device can be used for powders in standard funnels.FT-102Hall current meter/Loose density tester
1 Technical RequirementsFunnel (with one small hole diameter of 2.5mm and one 5.0mm each)
2 The funnel is made of stainless steel material and has sufficient wall thickness and hardness to prevent deformation and excessive wear.Bracket, base, and receiving cylinderThe bracket is used to fix the funnel. The base is used for installing brackets and receivinggraduated cylinderPlease adjust the level, stability, and absence of vibration. Adjust the height of the bracket and secure it with the included wrench, then install the funnel onto the bracket. receivegraduated cylinder
3 (Plate) placed on the base to collect powder.Balance (user provided)
4 称量100g；精度0.05g。stopwatch
5 The measurement time can reach 0.01 seconds.measuring cup
This device is equipped with a stainless steel measuring cup with a capacity of 25ml. Users can refer to the provisions of the national standard GB 1479-84 to complete the determination of the loose density of metal powder (leakage method).
1 Test Step Aggregationweighing50gOne sample, up to ±0.1g
2 .Block the small hole at the bottom of the funnel with your hand and weigh it50g Pour the sample into the funnel,
3 Note that the powder must fill the entire small hole at the bottom of the funnel.
4 Instantly, when the small hole in the funnel is opened and the timer starts, the timer stops immediately once the powder in the funnel has flowed out.Record the time required for all samples in the funnel to flow out, repeat three times, take the arithmetic mean, and record the time0.1s
.Note:
If the powder does not flow when the small hole is opened, you can tap lightly on the funnel to start the powder flowing. However, even if the powder does not flow out or stops flowing during the measurement process, it should be considered that this powder does not have fluidity.
Test results
Multiply the arithmetic mean of the measurement results of three samples by the correction factor of the funnel, and report the data in s/50g until 0.5s.powder/Particle analysis instrument; powder/Particle detection laboratory; powder/Rental of particle instruments; powder/
Particle analysis solutionFT-102Hall current meter/bulk densityMeasuring instrumentBasic configuration: Rack: 1 set; Funnel: 1 stainless steel (Φ 2.5mm, Φ 5.0mm) each; Measuring cup; 1 piece of stainless steel (Φ 31mm, 25ml); 1 stopwatch; 1 stainless steel overflow tray; 1 brush;steel ruler15cm 1 turn
instructions; warranty card; certificate.FT-102BOld model of automatic metal powder flowability tester;FT-102AVibration funnel loose density tester,FT-100AVibration density tester;FT-101Scott Capacity Meter Loose Density Tester,FT-102Hall current meter/Loose density tester-stainless steel material;FL4-1Hall current meter/Powder flowability tester-
