Battery high current discharge tester

WM-RS-F5000(10000)A/6V～12V

Battery high current discharge tester

Product Introduction

This machine is mainly used for high current discharge testing and capacity testing of batteries. It adopts an intelligent microcomputer control system and is connected to a computer for more complete control, monitoring, programming, recording, saving, printing and other functions. It has multiple working modes such as constant current segmented cycle static discharge that can be set. The entire working process can be automatically completed according to the programmed settings,

Battery high current discharge tester It has polarity reversal and overheat automatic protection devices, with high accuracy, convenient use, safety and reliability, and is an essential equipment for high current discharge tests of batteries.

Battery high current discharge tester

Technical Parameter

1.Discharge current: constant current10－5000A(10000A)Can be set.

2.Termination voltage:03.00V－13.00VCan be set.

3.Battery voltage: nominal 6-12VBattery.

4.Operation mode: Constant current segmentation,Loop idle and other settings can be set.

5.Discharge time: each segment1second-99hour59minute59Second x16Segments can be set.

6.Cycle times:1-999order(×16paragraph)Can be set.

7.Work record: Automatic recording of results for each section of work point,And it can be viewed on the machine.

8.Remote monitoring: can be controlled by connecting to a computer,monitor,Can set time interval(1to3600Any value in seconds)

Automatically record and save printing operation data.

9.Test accuracy: better than ±0.5％5000A(10000A)/12V.

10.Voltage input: ≤15V.

11.Discharge power: ≤ 2000(5000)W

12.Overheating protection: ≥85Automatically pause discharge at ℃, ≤65Automatic continuous discharge at ℃.

13.Cooling method: air cooling.

14.Power input: single-phaseAC220V±10％，50Hz， ≤80W.

15.Dimensions: Approximately 60 meters wide0Depth 550X high1750mm X 5.

16.Whole machine weight: approximately130kgX 5.