Analog Ultrasonic Testing Instrument ULTRAPROBE100

Our company is the first level agent of UE SYSTEMS INC in China, ensuring that all products are genuine and authentic through legitimate channels. We can provide demonstrations, training, testing, maintenance, and after-sales service for the entire series of ULTRAPROBE ultrasonic testing equipment products in China.

Analog Ultrasonic Testing Instrument ULTRAPROBE100

ULTRAPROBE 100 economical ultrasonic testing instrument (UP100)

ULTRAPROBE 100 Steam Drain Valve Tester (UP100)

Easy to use ultrasonic leak detector and steam trap detector, saving you energy, time, and money.

Detection Principle

ULTRAPROBE 100 receives high-frequency sounds from device operation, leakage, and discharge, converts them into electronic signals, and uses the "heterodyne method" to convert them into the audible frequency range of the human ear. Users can hear these sounds and observe changes in instrument intensity through headphones. The working principle of the "heterodyne method" is like a radio, which can accurately convert ultrasound signals for users to distinguish and understand.

Easy to use, cost-effective! Can detect compressed gas leaks, steam trap failures, and mechanical malfunctions.

Reasons for choosing Ultraprobe 100:

Easy to use

economyAffordable ultrasonic testing equipment

Use replaceable 9V dry batteries

Suitable for fault diagnosis and resolution

The characteristics of ultrasonic testing technology:

Ultrasonic waves are high-frequency short wave signals, and compared to the sound that humans can hear, the wavelength of ultrasonic waves is relatively small. Ultrasonic waves have the following characteristics:

Ultrasonic waves have strong directionality

Ultrasonic waves are prone to blockage or shielding

Ultrasonic instruments can be used in noisy environments

Ultrasound provides early warning of potential issues

Ultrasonic instruments are easy to use

The Ultraprobe 100 has an 8-bit sensitivity adjustment function (dB value scale) and LED intensity display, with each red LED representing 3dB, which can calculate the signal strength of the test point.

Configuration/Components

The standard configuration of Ultraprobe 100KT includes:

ULTRAPROBE100 Host

Scanning probe (including rubber sleeve)

Contact probe (including extension)

The ultrasonic generator

charger

battery

earphones

Operation Manual

Nylon carrying bag

Analog Ultrasonic Testing Instrument ULTRAPROBE100

UP100 Technical Parameters

Structure: ABS portable host, sensor with stainless steel casing

Circuit: SMD/solid-state hybrid heterodyne receiver

Frequency response: maximum response 36-44 kHz

Display: 10 segment LED bar chart (red)

Sensitivity selection: 8-bit 0-70

Power supply: 9-volt alkaline battery

Low battery display: LED

Earphones: Weight 2.5oz. Operating temperature -22 ° -167 ° F (-30 ° -75 ° C), 48 "shielded cable, 20lbs cable tension, frequency range 300-3000Hz, impedance 150 Ω, molded connection.

Probe:

Scanning probe (SCM-1) stainless steel ultrasonic piezoelectric type (single sensor)

Contact/probe (STM-1) stainless steel plug-in type with 5.5 "stainless steel waveguide.

Rubber focusing probe: shields noise and focuses on the detected ultrasonic signals.

Generator:WTG-1The ultrasonic generator

Response time: 300 milliseconds

Operating environment temperature: 32 ° -120 ° F (0 ° -50 ° C)

Related humidity: 10-95% non condensing up to 86 ° F (30 ° C)

Storage temperature: 0 ° -130 ° F (18 ° -54 ° C)

Size: 5.25 'X 2' X 8 '(13.3cm X 5cm X 20.3cm)

Weight: 11 oz (0.3kg)

Portable case: nylon soft bag with die cut foam