+GF+Signet transmitter universal Modbus module

+GF+Signet transmitter universal Modbus module

Install

If the 9900 basic unit is installed on a disk, the installation of plug-in modules can be done

Before or after installing the basic unit.

If using the attached wall installation kit (3-9900.392) for installation

9900 basic unit, please install the plugin module first.

If your device includes a direct conductivity/resistivity module or

Current circuit module, please install Modbus module first, and then proceed to

Install conductivity/resistivity module on Modbus module.

Before installing the Modbus module onto the 9900, please connect the output connector

Connect to the wiring terminals on the Modbus module. When inserting Modbus

When using the module, ensure that the wires are not exposed to 9900 power or collector opening

Squeezing of wiring terminals.

1. Disconnect the power supply of 9900.

2. Install the wiring harness before installing the module.

3. Carefully align the pins and connectors, and then firmly push the module into place

Position (see illustration).

4. Ensure that the cable is not squeezed between the module housing and the 9900 power supply or

Between OC terminals.

5. To disassemble the module, please squeeze the tongue, grab the module and pull it out directly

+GF+Signet transmitter universal Modbus module

Modbus module 3-9900. 270-MX enables Signet 9900 SmartPro ® The transmitter can

Connect to Modbus master compatible devices. Modbus module supports serial RS485 communication link

Maintain RTU or ASCII mode.

The Modbus module has an internal programmable network terminal for enabling communication through Modbus commands

The communication link.

Manufacturer's part number

3-9900.270-M1

3-9900.270-M2

3-9900.270-M3

3-9900.270-M4

3-9900.270-CB1

3-9900.270-CB2

3-9900.270-CB3

3-9900.270-CB4

5541-5005

5541-5010

ordering code

159 200 120

159 200 121

159 200 122

Coming Soon

159 200 123

159 200 124

159 200 125

Coming Soon

159 855 021

159 855 022