-0.1MPa vacuum vulcanizing machine

HY-50ZHB vacuum flat vulcanizing machine is used for rubber and plastic raw materials, plastics, PP, PA, PE, ABS, pigments, oil and chemical raw materials, etc. Place each raw material in the mold, clamp it between the electric heating plates of this machine, and apply appropriate pressure and temperature to shape the raw materials. The hot plate of this machine adopts a partitioned independent temperature control system for heating, which greatly improves the temperature uniformity compared to traditional single point temperature control systems. The machine also adopts a servo hydraulic system or level control force, with less control force and overshoot, and operates quietly.

1. Controller: Hengyu hydraulic control system, PLC microcomputer touch screen system, fully automatic control of force, temperature, time, exhaust, pressure maintenance, etc

2. Capacity: 50T.

3. Control system: Stepless control force of 1-50 tons, freely set, the system automatically adjusts to the required pressure and maintains it

4. Control range: 10 ℃~300 ℃ (higher temperatures can also be customized)

5. Heating system: divided into 6 independent temperature control zones, with a temperature control accuracy of plus or minus 0.1 ℃

6. Heating method: electric heating.

7. Cooling method: A. Introduce tap water for cooling; B. Introduce compressor cooling and circulating water cooling

7. Cold/hot press plate: 300 × 300mm/400 × 400mm/(or other sizes)

8. Number of layers of pressure plate: A.1 layer (heating+water cooling), with hot and cold plates together; B. 2 layers (upper layer heated, lower layer cooled)

9. Heating rate: It takes about 10 minutes from room temperature to 170 ℃

10. Cold pressing plate: A. Mold steel; B. Industrial aluminum

11. Vacuum function: -100KPa (-0.1MPa). Outer space -0.11MPa.

Vacuum holding time: The vacuum degree does not decrease by more than 0.01MPa within 3 minutes

12. Hydraulic system: A. Three phase AC motor+hydraulic; B. Three phase AC motor+proportional valve; C. Electro hydraulic servo system; D. High configuration electro-hydraulic servo system

13. Cylinder stroke: Max200mm

14. Cylinder speed: about 0-15mm/s (automatic transmission control)

15. Volume occupied space: approximately 1150 × 850 × 1650 mm (W × D × H)

16. Power supply: 3 ∧, AC380V，20A

17. Weight: Approximately 960kg