Classification of IP protection levels for rain test chambers-Chemical Instrument Network

Rain Test ChamberThe IP level is standard equipment, which needs to be installed in a specially designed laboratory for manual simulated rain testing of the product. The water inlet and waterproof facilities in the laboratory must be installed in place. Equipment can be used to assess and determine whether the enclosures and seals of electrical and electronic products, various electrical appliances, and lighting fixtures can ensure good working performance of the equipment and components after or during water testing. The device can simulate the external rainy environment and fully reproduce the impact of the external rainy environment on the product.

IP stands for Ingress Protection The IEC IP protection level is important for the safety protection of electrical equipment The IP protection level system provides a method for classifying products based on the dust, water, and collision resistance of electrical equipment and packaging. This system has been recognized by most European countries, drafted by the International Electrotechnical Commission (IEC), and announced in the IED529 (BS EN 60529:1992) outer packaging protection level (IP code).

IP1 and IP2 are suitable for external lighting and signal devices, as well as for protecting the outer shell of automotive lighting fixtures, and are used for drip testing chambers.
IPX1 prevents water droplets from entering and prevents vertically dripping water droplets.
IPX2 can still prevent dripping when tilted at 15 degrees.
IPX3, IPX4 rain test box, swing tube rain test box, this product is suitable for external lighting and signal devices as well as protection of automotive lamp housings. There are two types of devices, one is an external swing tube rain test device that is suitable for large objects, and the other is a rain test box for small objects. The former requires a waterproof room to be prepared and no other testing equipment can be placed around it. A sewer needs to be installed underneath, while the latter is relatively simple, just connect a water pipe and place it in a laboratory, but it is one meter away from the surrounding equipment.

IPX5 and IPX6 flushing test devices can be moved to any suitable location for anti spray testing, and the flow rate, pressure, time, and spray range can be adjusted according to the required requirements. The experiment can be conducted immediately.

The rain test chamber is suitable for testing the waterproof performance of automotive lighting fixtures, wiper blades, waterproof strips, locomotive instruments, and low-voltage electrical enclosure protection. It mainly provides a water mist test environment that meets the testing standards of IP protection level and is used for reliability identification of electrical, electronic, and lighting samples. The equipment meets the testing requirements of GB/T4208 standard.