Zhonglian Pump Truck Hydraulic Pump A2F32R6.1P5

Zhonglian Pump Truck Hydraulic Pump A2F32R6.1P5There are up to 9 types of complete specifications, mainly including straight axis variable displacement pumps, with diversified control, mainly relying on pressure to control variables. Work flexibility and provide traffic compensation. Vickers plunger pumps have low operating noise and can meet the demanding industrial conditions of today. The noise level of each pump is close to or lower than the noise of the motor driving the pump. The noise is determined by a dedicated timing configuration, and this measure also minimizes pressure "pulsation" in the output flow.

Bosch REXROTH Rexroth from GermanyZhonglian Pump Truck Hydraulic Pump A2F32R6.1P5How to implement variables?

This pump changes the plunger stroke (changes the variable head angle), and the variable is achieved by changing the stator eccentricity. When the speed exceeds 1500rpm, it is advisable to use fuel supply with a pressure of around 0.7MPa. In open mode, the flow rate of the fuel supply pump should be 130% of the pump, and in closed mode, the flow rate of the fuel supply pump should be 35% of the pump.

Zhonglian pump truck hydraulic pump oil leakage:

1. Firstly, check for any external oil leaks, paying special attention to the oil seals at the front and rear ends of the crankshaft;

2. The rupture, damage, aging, or wear of the oil seal at the front end of the crankshaft, or the wear of the crankshaft pulley and oil cover, can cause oil leakage at the front end of the crankshaft.

The oil in the working chamber composed of the plunger and cylinder bore is connected to the suction and discharge chambers of the pump through the oil distribution plate. The variable mechanism is used to change the inclination angle of the inclined plate, and the displacement of the pump can be changed by adjusting the inclination angle of the inclined plate.

Regarding the excessive current of the hydraulic pump in the Zhonglian pump truck, the cause of the malfunction is:

1. Excessive export pressure;

2. Excessive viscosity of the melt;

3. Poor assembly of shaft seal;

4. Wear of shaft or bearing;

5. Countermeasures for motor faults;

6. Inspect downstream equipment and pipelines;

7. Test viscosity;

8. Check the shaft seal appropriately;

9. After parking, check if the hand cranked vehicle is too heavy;

10. Check the electric motor.

The main product specifications are as follows:

A2F12R6.1B5

A2F23R6.1P5

A2F90L6.1P5

A2F16W6.1Z2

A2F28L6.1B6

A2F32L6.1B6

A2F180W6.1B2

A2F45R6.1P6

A2F16L6.1B6

A2F180L6.1B5

A2F125W6.1B3

A2F107W6.1Z3