Turbine oil filter malfunction

NegotiableUpdate on 07/02

Model

Nature of the Manufacturer: Producers

Product Category

Place of Origin

Online Consult

Overview

The explosion-proof turbine oil filter adopts a new type of aggregation and separation technology for online processing of turbine oil and lubricating oil for steam turbines, gas turbines, water turbines, and turbine compressors in various industries, ensuring unit regulation, removing a large amount of water and achieving precise filtration of impurities, effectively breaking down oil emulsification, and achieving rapid dehydration. This machine uses physical means to quickly remove harmful components such as water, impurities, and gases (acetylene, hydrogen, methane, etc.) from oil without affecting its composition and performance; Can effectively ensure the normal operation of oil equipment; At the same time, increase the service life of oil equipment to avoid accidents.

Product Details

Turbine oil filterThe machine adopts new aggregation and separation technologies for online processing of turbine oil for steam turbines, gas turbines, water turbines, and turbine compressors in various industries, ensuring the normal operation of unit regulation and lubrication systems. It can also be used for bottom viscosity adjustment and cooling oil treatment, mainly used for turbine oil treatment in generator sets, and can also be applied to hydraulic oil, refrigeration oil, and other low viscosity lubricating oils that require removal of a large amount of moisture and precise filtration of impurities.

Turbine oil filterFault:
Common faults of turbine oil filter: Vacuum degree does not meet technical standards
Reason ①: The filtered oil contains too much water and the vacuum pump extracts too much water vapor from the gas. Solution: This is a normal phenomenon and needs to be filtered multiple times. ② Due to the different altitudes of the usage location, it does not affect the vacuum degree change under standard atmospheric pressure conditions. Solution: It is a normal phenomenon to increase the temperature of the oil to evaporate the water. ③ Inside the vacuum pump, the vacuum oil is below the oil level line. Solution: Increase vacuum oil. ④ Vacuum oil has a high water content due to its long usage time. Solution: New oil needs to be replaced. ⑤ Seal and leak oil at each connection. Solution: Check and repair.
Common faults of turbine oil filter 2: pressure of 0.3mpa under normal working conditions
Causes: ① The machine's oil outlet pipe is too long, the conveying oil level is too high, the oil outlet valve is small or the pipe is too small. Solution: Improve the environment. ② The oil filter absorbs a lot of impurities. Solution: Peel off the outer layer of filter paper.
Common Malfunction Three of Turbine Oil Filter: Vacuum Pump Fuel Injection
Reason ①: The filtered oil has a high water content, causing the oil float to rise and be sucked into the vacuum pump, resulting in an increase in oil level inside the vacuum pump. Solution: When replacing the vacuum oil, do not exceed the oil level line. ② The sealing gasket inside the vacuum pump is displaced or damaged. Solution: Maintenance

Turbine oil filterAdvantages:
1. This series of products has multiple technologies, integrating vacuum drying, separation engineering technology, coagulation technology, and secret filtration technology for adsorption
2. It can automatically drain without stopping the machine, so that the dirty old oil meets the standard for using new oil
3. Users can freely choose device colors according to their preferences.