Straightening and wire cutting machine (1mm-2mm)

The straightening and cutting machine (1mm-2mm) is used for straightening and cutting steel bars with a diameter of 1-2 millimeters. The cutting length can be customized according to customer requirements. The equipment produced by our factory can straighten and cut stainless steel wire, aluminum wire, cold drawn wire, galvanized wire, iron wire, steel wire, steel bar, plastic coated steel wire, etc., with neat cutting, small error, and good performance.

The machine has a reasonable structure, stability and reliability, simple operation, high degree of automation, and operators can manage multiple machines at the same time, greatly improving production efficiency. It is a necessary specialized equipment for hardware, network cable and other manufacturers.

This machine consists of an inlet section, a straightening section, a cutting section, etc. Its linear gun can automatically cut the wire to a fixed length and automatically drop the material. After loading, the machine performs automated operations.
This machine can be widely used for hardware products Arts and Crafts. Various fields of daily necessities production. For example: bicycle basket Banner Umbrella stand. cage. Refrigerator shelves Electric fan cover Construction silk Straightening and cutting of various metal wires such as wire mesh screens. This machine is mainly used for straightening and cutting cold drawn steel wires and other non-ferrous metal wires, and can be widely used in hardware products Arts and Crafts. Various fields of daily necessities production. For example: bicycle basket Banner Umbrella stand. cage. Refrigerator shelves Straightening and cutting of various metal wires such as fan covers. The maximum straightening straight diameter is 4. If you need to increase the length of the fixed length, it can be customized.

Construction: The straight wire machine consists of a straightening cylinder, a traction mechanism, a cutting mechanism, a steel bar fixed length frame, a frame, and a driving device.

Operating principle: The motor is driven by a belt to increase the speed, causing the straightening cylinder to rotate at high speed. The steel bars passing through the straightening cylinder are straightened, and the rust on the surface of the steel bars is removed by the straightening die; Driven by an electric motor through another pair of reduction belts and a gearbox, it drives two conveying pressure rollers to pull the steel bars forward, and drives the crank wheel to move the hammer head up and down. When the steel bars are adjusted to the predetermined length, the hammer strikes the knife holder to cut the steel bars. When the cut steel bars fall into the receiving rack, due to the action of the spring, the knife holder returns to its original position, completing one cycle.

Installation and Debugging

1. This machine should be installed on a relatively flat foundation, and some soft cushions should be placed on the foundation to prevent the machine from high-speed and ground vibration;
2. The host is connected to the slide on the same straight line, until it is the smoothest;
3. Rotate the punch head by hand to see if it is engaged with the cutting assembly. If it is not engaged, adjust the height of the slide rail bracket pulley;
4. Durable slide limit lock plate;
5. Connect the slide spring;
6. The motor on top is consistent with the cutting wheel tip;
7. Adjust, slowly bend, increase the angle of the middle three pieces, and if there is a bean grain bend, reduce the angle;
8. Adjust the slider inside the slide to the size you need (measured from the bottom of the cutting section), and tighten the slider with screws.