Shanghai cold and hot type open mill (dual speed regulation)

NegotiableUpdate on 05/06

Model

Nature of the Manufacturer: Producers

Product Category

Place of Origin

Online Consult

Overview

The open mill, which can be heated or cooled, with two on top of each other, is a powerful tool for rubber mixing for R&D users. Another characteristic of this model of open mill is fast heating, good stability, and no danger or pollution of oil heating open mills. It is indeed worth adopting.

Product Details

1.Mixed capacity:about0.1-2kgs

2.roller temperature:Self generated water temperature~+300℃

3.temperature control:City Water Cooling+Thermal medium circulation machine. According to the automatic adjustment of the temperature controller, when the temperature is low, the heat medium circulation machine inputs the heat source medium for circulating heating; During rubber mixing, the temperature of the roller increases, the solenoid valve opens, and tap water enters to cool down. At the same time, the heat source is cut off, and the two work alternately.

4.Temperature Display:Degree ±2℃

5.Number of motors: 2platform

6.Front roller speed: 10-30r/min,adjustable

Note: This machine uses a frequency converter to control the motor speed. When an overload condition occurs, the motor power is automatically cut off to protect as much as possibleThe lifespan of the motor!

7.Front and rear roller speed ratio:1：1.4

8.Roller size:F155mm×L350mm, surface plated with hard chrome,The surface is polished with a mirror finish.

9.Roller spacing: 0.1～10mmadjustable.This machine is equipped with a powerful handle that can adjust the spacing between the rollers during rubber mixing.

10.Safety device:

A.There is a safety lever at the top, which stops immediately upon contact;

B.There are safety tapping devices on the left and right sides of the front and rear, and the tapping stops the machine+reverse1/4-1/3Circle device;

C.Front and rear knee collision safety devices, knee collision will stop the machine+reverse1/4-1/3Circle device.

11.Roller lubrication:Adopting wear-resistant bearings

12.Bearing cover: Separate the exposed surface of the bearing to prevent rubber samples from entering the bearing chamber and extend the service life of the bearing;

13.Material blocking plate: The width can be flexibly adjusted, and the amount of rubber material can meet the requirements.Less adhesive material, adjust towards the middle, and more adhesive material can be adjusted towards both sides.

14.Material receiving basin: made of stainless steel, easy to clean, pollution-free and rust free.

15.Mechanical structure: Steel plate (lighter weight, smaller volume, higher mechanical strength, and better toughness than traditional cast iron)

16.volume(W×D×H) 1200×550×1300mm

17.power supply 3∮，AC380V，15A

18.Weight: Approximately620kg