Saw blade cleaning machine

Product introduction: After processing, the saw blade needs to be cleaned before it can be packaged and sold. Using the saw blade cleaning machine greatly improves our production efficiency. The saw blade cleaning machine consists of a frame, a conveying platform, a cleaning device, a water absorbing component, and a dryer.

After processing, the saw blade needs to be cleaned before it can be packaged and sold. Using the saw blade cleaning machine greatly improves our production efficiency.

The saw blade cleaning machine consists of a frame, a conveying platform, a cleaning device, a water absorbing component, and a dryer.

Operation of cleaning machine:

1. Follow the general operating procedures for mechanical equipment.

2. Before starting work, it is also necessary to comply with:

a、 Check for any water leakage in the piping system, and if so, notify maintenance personnel for repair.

b、 Check if the cleaning solution is sufficient, and if not, promptly add more cleaning solution.

c、 First, perform a jog test, then run it for 2-3 minutes without load to check if the transmission system (motor, coupling, etc.) and conveyor belt are moving smoothly. Only after confirming that everything is normal can production begin.

3. In work, it is also necessary to comply with:

a、 The cleaned oil cylinders and other components should be smoothly transported to the metal brush head on the transport vehicle

b、 After work, the cleaned oil cylinder cannot be parked on the transport vehicle. Press the stop button to stop the entire machine.

c、 The cleaning solution should be regularly supplemented with water and a certain proportion of dirt cleaning agent to replenish consumption, keeping the liquid level at a certain height. If the cleaning effect does not meet the specified process requirements, all cleaning solutions should be replaced.

Installation and debugging:

1. Connect the power according to the direction indicated by the motor and pump, and the motor rotates clockwise. Please ground the wire

2. After normal startup, run the machine empty for a few minutes before resuming normal operation.

3. The high-pressure rubber hose should be connected according to each joint. There should be sufficient tightening torque and reliable anti loosening measures. After being fully loaded for a period of time, Tian Hao tightened it again.

4. When replacing various brush heads, sufficient tightening torque and reliable anti loosening measures should also be taken.

5. When used in winter, the equipment should be placed in a warm room (above 15 ° C) for 12-24 hours before adding water for debugging and use.

6. Isolate the distribution box from the water source and pay attention to safe operation.