Welcome Customer !

Membership

Help

Shanghai Zhongyu Technology Co., Ltd
Custom manufacturer

Main Products:

instrumentb2b>Products

Shanghai Zhongyu Technology Co., Ltd

  • E-mail

  • Phone

  • Address

    No. 3130 Jinshajiang Road, Jiading District, Shanghai

Contact Now

SMC electrical proportional valve

NegotiableUpdate on 05/07
Model
Nature of the Manufacturer
Producers
Product Category
Place of Origin

Overview

SMC electrical proportional valve ITV2030-012L3 belongs to the ITV2000 series. It belongs to the same series as ITV2030-012L, with the main difference being the cable plug form and other details. Core function: Continuously adjust the compressed air pressure by inputting electrical signals (such as 4-20 mA), commonly used in situations where precise pressure control is required. Type: Pilot operated proportional pressure valve, single valve structure.

Product Details

SMC electrical proportional valveITV2030-012L3 belongs to the ITV2000 series. It belongs to the same series as ITV2030-012L, with the main difference being the cable plug form and other details. Core function: Continuously adjust the compressed air pressure by inputting electrical signals (such as 4-20 mA), commonly used in situations where precise pressure control is required. Type: Pilot operated proportional pressure valve, single valve structure.

The model meaning of ITV2030-012L3 is roughly as follows:

ITV: Electrical Proportional Valve

2: 2000 series (corresponding to ITV2000)

03: Pressure range 0~0.5 MPa

0: Power supply voltage DC 24 V

1: Input signal 4-20 mA (current type)

2: Monitoring output 1-5 V analog quantity

L: Threaded interface Rc

3: Cable plug L (right angle type 3m), which is the main difference from ITV2030-012L.

Key points for use and selection

Air source treatment: It is recommended to install a filter with a filtration accuracy of less than 5 μ m and an oil mist separator in front of the valve to ensure that the air source is clean and dry. It is usually not recommended to install an oil mist device in front of the valve.

Residual pressure treatment: After power or gas interruption, there may be a residual pressure of about 0.005 MPa at the outlet. To fully depressurize to 0, a three-way solenoid valve can be installed on the outlet side for discharge.

Safe operation: To extend the service life, the power should be cut off before cutting off the gas source to avoid the electromagnetic valve from producing a buzzing sound when the pressure is lost.

The following parameters are based on ITV2030-012L, while ITV2030-012L3 has similar core performance indicators such as pressure, flow rate, and accuracy, with the main difference being the cable plug form.

Parameter specifications

Pressure range 0~0.5 MPa

High supply pressure 1.0 MPa

Power supply voltage DC 24V

Input signal current type DC 4-20 mA (collector)

Monitoring output analog output DC 1-5 V

Interface caliber Rc 1/4

Sensitivity of approximately 0.2 kPa (at 100 kPa)

Linearity ≤ ± 1% F.S

Delay ≤ 0.5% F.S

Repeatability ≤ 0.5% F.S

Temperature characteristics ≤ 0.12% F.S./℃

Environmental temperature/fluid temperature 0~50 ℃

Output pressure display accuracy 2% F.S. ± 1 digit

Protection level IP65

Current consumption is approximately 0.12 A

Cable plug right angle type, 3 m (L)

SMC electrical proportional valve