SBLC-3200 Continuous Monitoring System for Smoke Emissions (Dilution Method)

Product Introduction

The SBLC-3200 continuous monitoring system for flue gas emissions (dilution method) consists of four basic parts: smoke monitoring subsystem, gaseous pollutant monitoring subsystem, flue gas parameter monitoring subsystem, and system control and data processing subsystem. It can monitor SO in gases₂、NOx、O₂Parameters such as dust, temperature, pressure, flow rate, humidity, etc. The measured gas is filtered by the sampling probe filter, diluted in a fixed ratio through the probe, and then enters the analyzer for measurement through the sampling tube. The analyzer uses ultraviolet fluorescence method to measure SO₂The composition and chemiluminescence methods are used to measure NOx components, both of which can accurately measure ppb level gaseous pollutants. The dilution gas used to dilute the flue gas sample is high dehumidification and dust removal gas. After a fixed proportion of dilution of the flue gas sample, the dew point of the diluted sample gas can be ensured to be around -30 ℃. Therefore, the sampling tube does not need to be heated throughout the entire process, which not only effectively solves the problem of diluting SO by condensation water analysis₂This leads to technical difficulties such as low measurement results, while also solving the high operating costs and safety hazards caused by the full process heating measurement of hot and wet methods.

Product Features:

The product smoke does not require full high-temperature heating or condensation dehumidification;

The heat tracing tube directly uses polytetrafluoroethylene tube, without the need for full heat tracing, saving costs and avoiding safety hazards;

When the distance between the monitoring point and the analysis cabin exceeds 70m, conventional heat tracing pipes cannot be used, and the dilution method monitoring system is not affected;

The ultraviolet fluorescence method and chemiluminescence method have significant advantages in measuring gaseous pollutants in the field of ultra-low measurement;

It can achieve full process calibration and backend calibration.

Product Application:

Exhaust emission testing and process control for coal-fired power plants, waste incineration power plants, cement plants, glass plants, lime plants, ceramic plants, sintering, coke ovens, desulfurization processes, denitrification processes, etc.

Product Specifications