QH electric actuator

QHOutline dimension drawing and parameters/Angle adjustment

QH100-QH200? bType size

05Type10Type16Layout diagram of limit cam and micro switch of type

Angle adjustment

① Electrical limit adjustment

Release the top thread of the limit cam and make itQingyuan MianThus adjusting the cam angle to change the position of the micro switch's impact field, after determining the position, sign and fix it The top thread of the cam has been adjusted.

⑴ Use the handle to rotate the actuator to the fully open position, loosen the lock nut, thread the special top wire to make it align with the binding ring stopper, and then rotate in the opposite direction180degree And lock the nut.

(2The adjustment of the binding ring block at the land closing position adopts the same method as above.

QHAngle adjustment

25type-200Layout diagram of limit cam and micro switch of type

toThe Dan Zheng of the equipment limit

QHInstallation of/Connect a door/wiring

■ Installation

Epidemic prevention sites can be indoor, outdoor, or on the groundF

Du Zhuang Zhu Yi Yun Page:

⑴ This product belongs to non explosion proof products, so it cannot be installed indoors with explosive gasesi

(2When installing in a water jet setting, please add a protective cover to avoid water seepage and overheating Bad machinei

Indoor installation should also reserve space for incoming lines and manual operationsi

Please add a protective cover to the five room treatment equipment to reduce direct sunlight exposureIInch, avoid adding components inside the body Speedification

■ Connect the valve

①Manually rotate the valve, confirm that it is functioning properly, and then move it to the fully closed positioni

②Using screwsGently lift the bracketFixed on the valvei

③Insert the coupling onto the valve stemi

Cheng QueAfter setting the actuator status to the US position, insert its output shaft into the valve stem and fix it in place In the couplingi

⑤ Fix the actuator onto the bracket with screws｛Due to the unavoidable limitations of the binding device Obstacles and occasional misalignment of screw holes are common situations, and we only need to manually shake them A slight rotation of the rod and actuator can solve such problems)；

Shining signed cattleScrew,Installation completed.

■ Wiring production connection

①Recommended to use6 6-611Cable lines are used to ensure the safety and reliability of the connections.

• WillThe cable is fixed to the wiring according to the circuit diagram through a lock cover and a clue, and the wire head is fixed to the wiringS子 Up, then lock the cable cover to secure the cable.

②When using cable conduits, waterproof measures should be taken.

As shown in the figureAs shown, the installation position of the valve actuator should be higher than the position of the cable conduit to ensure The water ball will not flow into the actuator along the cable.

Power on

①Determine the input voltage based on the voltage indicated on the product nameplate or circuit diagram, QHThe input voltage of the series products is as follows:

(1)AC220V±10% 50/60HZ

(2)AC380V±10%

(3)AC110V±10%50/60HZ

(4)DV24V-DC220V

②must■ Fuses or short-circuit switches must be used,Its capacitySize in front of electric actuator Frequently work with you］22 It is more suitable between multiples.