Pilz PILZ relay PNOZ m EF 2MM in stock original

NegotiableUpdate on 05/07

Model

Nature of the Manufacturer: Producers

Product Category

Place of Origin

Online Consult

Overview

Pilz PILZ relay PNOZ m EF 2MM in stock original product introduction: Product material number: 772171 $r $n Configurable small safety controller PNOZmulti 2, expansion module, safety monitoring 2 shafts.

Product Details

Pilz PILZ relay PNOZ m EF 2MM in stock originalProduct Details

Pilz PILZ relay PNOZ m EF 2MM in stock original

PNOZ m EF 2MM

Product Material Number: 772171

Configurable small safety controller PNOZmulti 2, expansion module, safety monitoring 2 axes.

Technical data

Electrical data

The purpose of UINT1	Module power supply
Internal voltage source	Through basic modules
Voltage type of UINT1	DC

Proximity switch input

Programmable monitoring frequency of proximity switch (without hysteresis)

0.1 Hz - 5 kHz

Input incremental encoder

The number of inputs to the incremental encoder	2
Connection (incremental encoder)	8-pin Mini IO hole connector
The phase of differential signals A,/A, B and the tolerance of incremental encoders	90° ±30°
Programmable monitoring frequency without hysteresis for incremental encoders	0.1 Hz - 500 kHz

input

Potential isolation between input and internal module bus voltage

Yes, it is

environmental data

Environmental temperature standard	EN 60068-2-14
Environmental temperature expressed in degrees Celsius	0 - 60 °C
Storage temperature standard	EN 60068-2-1/-2
Climate suitability standards	EN 60068-2-30 EN 60068-2-78
Allow/Do not allow condensation	Not allowed
The maximum installation height above sea level is not limited by the rated power	2000 m
EMC meets the standard ..	EN 61131-2
The standards on which vibration testing is based	EN 60068-2-6
The acceleration specified in Standard 1 is the basis for impact stress testing	15 g
Standards for gap and creepage distance to be followed	EN 61131-2
Overvoltage level	Two
Specification for gap and creepage distance pollution level	2
Protection level standard	EN 60529
Protection type, installation
Protection type, casing
Terminal protection type

era

Response time after exceeding the limit value

1/f_actual + 16ms

Potential Separation

Potential isolation between circuit components 1	Sensor and system voltage
Potential isolation type 1	Functional insulation
Potential isolation between circuit components 2	Sensor 1 and Sensor 2
Potential isolation type 2	Functional insulation

Mechanical data

Installation location	Horizontally located on the top hat guide rail
DIN power rail dimensions (EN 50022)
Lower part of shell material	PC
Front panel of shell material	PC
The material of the upper part of the shell	PC
connection end	Screw end Spring loaded terminal
Terminal style	Pluggable
Allowable cross-sectional area of flexible AWG conductor	24 - 12 AWG
height dimension	101.4 mm
width dimension	22.5 mm
depth dimension	111 mm
Net weight	120 g
Total weight	130 g