Parker plunger pump

NegotiableUpdate on 05/14

Model

Nature of the Manufacturer: Producers

Product Category

Place of Origin

Online Consult

Overview

Parker plunger pump with die cast aluminum casing, fluid static pressure clearance compensation, sliding bearings, single or multiple pumps. High precision machined gear pairs.

Product Details

　　Parker plunger pumpBelonging to a positive displacement pump, it is particularly suitable for long-distance pipeline transportation of high solid content and viscous materials. Its advantages are very stable and reliable operation, but with high noise. The conveying pressure can reach up to 130Bar, and the displacement can reach 0.5-500 cubic meters per hour. Widely used in sewage treatment, solid waste treatment, mining metallurgy, dredging, oil and chemical industry, power plants, cement industry and other fields.

　　Parker plunger pumpApplication:

Mini sliding steering accessory

Zero turning radius lawn mower

Golf course maintenance equipment

• Vacuum cleaner

• Wood cutting machine

• Conveyor belt

• Combine harvester

• Winch

Spiral drill

Portable irrigation system

• Rear hole spiral drill

• Featured harvesters such as potatoes, tomatoes, nuts, leafy vegetables, sugar, cotton, coffee, and grapes

• Combination cutting table driver

• spray

Scissor lift

• Snow removal

Salt and sand spreader

Oil and gas mixer truck

• Manual lever with feedback (with or without center switch)

• Hydraulic ratio with or without feedback

Electronic proportion with or without feedback

• Electric switch control

Electric proportional and hydraulic exceeding authority

• Speed related control

• Hydraulic compensator

• Electric shut-off valve

• Combination hydraulic/electric cut-off

• Rinse valve

Oil replenishment pressure filter with electric or mechanical blockage sensor

If the plunger pump cylinder is fitted with a copper sleeve, it can be installed by replacing the copper sleeve. Firstly, adjust the outer diameter of a set of plunger rods to a uniform size, and then polish the outer diameter with sandpaper of 1000 # or above. There are three methods for installing copper sleeves on cylinder bodies: (a) cylinder body heating and hot installation or copper sleeve low-temperature freezing and extrusion, interference fit assembly; (b) Assemble with Loctite adhesive, which requires grooves on the outer diameter surface of the copper jacket; (c) Tap the cylinder hole, thread the outer diameter of the copper sleeve, apply Loctite adhesive, and screw it into the assembly.