Laboratory organic solvent spray dryer is equipped with tail gas dedusting device as standard

Laboratory organic solvent spray dryer is equipped with tail gas dedusting device as standard

Laboratory organic solvent spray dryer is equipped with tail gas dedusting device as standard

Product DescriptionProduct Description

JT-5000Y organic solvent spray dryer is mainly used in universities, research institutes and laboratories of food, medicine and chemical enterprises to produce micro particle powders. It has broad spectrum applicability to emulsions and suspensions, and is suitable for drying heat sensitive substances such as biological products, biological pesticides, enzyme preparations, etc. Because the sprayed materials are subject to high temperature only when sprayed into aerosol particles, they are only heated instantly, which can keep the active ingredients of these active materials intact after drying.

Main featuresPrincipal Character

17-inch touch screen operation control, fully Chinese operation interface, PID constant temperature control for heating temperature, can directly set inlet temperature, air flow rate, automatic needle frequency, pump speed, achieve data acquisition, process monitoring and control,Adopting a dual control mode of fully automatic and manual control, the entire experimental process is dynamically displayed on a color touch screen (animation);

2. The self-priming peristaltic pump enters the drying chamber from the container through the nozzle, and the compressed nitrogen enters the drying chamber from the outer casing to make the liquid micronized. The heated nitrogen enters the drying chamber from the upper layer and meets the liquid particles after spray, and the articles begin to dry. The dried powder particles are separated from the exhaust gas through the rotary air separator and then enter the collection bottle. The air flow containing organic steam is cooled down in the heat exchanger, and then the solvent is condensed and recovered in the refrigeration device. The clean nitrogen enters the next cycle;

3. The spray dryer in the inert gas closed cycle laboratory will make these generated waste gases sealed in the system and collected in the next process, which can reduce environmental pollution and is conducive to environmental protection. avoidThe problem of waste gas pollution in raw material production;

4The closed laboratory spray dryer enables the materials to circulate in the closed drying system, which can avoid the contact between organic solvent gas and external oxygen air, greatly improves the safety in production, and effectively solves the problem of flammable and difficult drying of organic solvent materials;

5. The drying and transportation of materials in a closed-loop system with antioxidant properties serve the purpose of isolating them from oxygen, ensuring the quality of drying and production of easily oxidizable materials;

6. During the experiment, the poly spray head is not eccentric when atomizing and will not affect the recovery rate when spraying to the bottle wall when spray. The spray head can move up and down to change the atomization position to improve the drying effect of spray; The spray head has very good adaptability to high viscosity materials, and the phenomenon of blocking the spray head rarely occurs;

7. Standard exhaust dust removal device reduces environmental pollution, effectively improves yield, and increases the yield of difficult to recycle materials;

Technical specificationsTechnical Parameter

1、Material handling capacity:20-2000ML/H (depending on the difference in solid content of the material)

2. Real time PID constant temperature control technology, heating and temperature control accuracy: ± 1 ℃;

3Inlet air temperature control: achievable250 ℃, outlet temperature: up to 140 ℃

4. Nozzle diameter: 0.5mm/0.7mm/0.75mm/1.0mm/1.5mm/2.0mm optional, and can be customized according to requirements

5. The whole machine is made of stainless steel, with two fluid spray atomization structure. The spray, drying and collection system is made of high quality SUS304 stainless steel (with observation mirror)

6Whole machine power:2KW /220V

7. It can be used for spray drying of aqueous and organic solutions