KGGRP1 Tin Plated Copper Wire Shielded Silicone Rubber Control Flexible Cable

KGGRP1 Tin Plated Copper Wire Shielded Silicone Rubber Control Flexible Cable

Suitable for control and monitoring circuits with rated voltage of 450/750V and below in high-temperature industries such as steel, smelting, power plants, coking plants, aviation, metallurgical machinery, petroleum, and chemical industries.cableIt has excellent characteristics such as high temperature resistance, flame retardancy, radiation resistance, aging resistance, ozone resistance, waterproofing, and also has good cold resistance and weather resistance.

1： Product execution standards

The flame retardant and fire-resistant characteristics test shall comply with GB12666-90 standard

2： Usage characteristics

1. Rated AC voltage: U0/U 450/750KV

Maximum operating temperature: 180 ℃

2. Environmental temperature: Silicone rubber sheath: fixed installation -60 ℃, non fixed installation -20 ℃

3. The temperature for cable installation and laying should not be lower than -20 ℃.

4. Allowable bending radius for cables: The minimum allowable bending radius for non armored cables is 6 times the outer diameter of the cable

3： Basic model and name

KGG silicone rubber insulated and sheathed control cable

KGGR silicone rubber insulated and sheathed control flexible cable

KGGP silicone rubber insulated and sheathed copper wire braided shielded control cable

KGGRP silicone rubber insulated and sheathed copper wire braided shielding control flexible cable

KGGRP1 silicone rubber insulated and sheathed tin plated braided shielded control flexible cable

Note:

If a flame-retardant silicone rubber cable is required, add ZR before the model number;

Silicone rubber insulated and sheathed cables can replace silicone rubber insulated and sheathed heat-resistant control cables when there are many cores and large cross-sections,

The applicable situation is similar to that of silicone rubber sheathed cables, with a long-term use temperature of -60-105 ℃.

Copper wires in the 3 conductor cores can be plated with tin.

4： Main technical indicators

1. The DC resistance of the finished cable conductor (in accordance with GB3956 regulations) shall refer to Table 3 in Appendix A.

The insulation resistance at 2.20 ℃ shall not be less than 500M Ω/KM.

3. The finished cable shall withstand AC 50HZ3.0KV/5min voltage test without breakdown.