K2 reciprocating coal feeder motor for mining feeder drive device

K2 reciprocating coal feeder motor for mining feeder drive deviceConnect the power supply to U1V1W1, swap any two wires to reverse. Be sure to check the three-phase power supply to avoid burning the motor due to phase loss. Not covered by the warranty.

K2 reciprocating coal feeder motor for mining feeder drive deviceAccurately process the friction position, with excellent lubrication and stable operation. It can be manually adjusted in speed. After the feeder is installed in place, start the motor without load to make the feeder run without load. After no abnormal phenomena are found during 20 minutes of idle operation, stop the machine and check the temperature rise of the motor and reducer. If everything is normal, then check and tighten the relevant bolts and nuts, restart the machine, and slowly open the coal bin to allow the coal flow to enter the feeder from small to large, so that the feeder can be put into normal operation.

The conveying process of the coal feeder can be divided into the following steps: 1) Scraper falling: When the chain rotates, the scraper is driven down and comes into contact with the coal blocks on the coal pile. 2) Coal chunks are lifted: After the scraper falls, the scraper in contact with the coal pile lifts the coal chunks and transports them forward with the movement of the chain. 3) Coal chunks are thrown out: When the scraper moves forward a certain distance, the coal chunks on the scraper will be thrown out by centrifugal force. 4) Coal chunks fall into the conveyor belt: The thrown coal chunks will fall onto the conveyor belt below and continue to be transported forward. The working principle of the compound coal feeder is to drive the chain wheel to rotate through the electric motor, so that the chain drives the scraper to transport coal. Under the synergistic effect of chains and scrapers, coal is lifted, thrown out, and falls into the conveyor belt, achieving continuous transportation of coal. Understanding the working principle of the compound coal feeder can help us better use and maintain this equipment, improve the efficiency and safety of coal transportation.

The reciprocating feeder is suitable for bulk material transportation in mines, coal mines, coal preparation plants, transfer stations, coal conveying workshops, port bulk material docks, etc., achieving uniform feeding of bulk materials such as ores, sand coal, and grains.