High temperature resistant gas ring blower, thermal circulation conveying gas vortex pump

High temperature resistant gas ring blower, thermal circulation conveying gas vortex pump

Features:

1. It has dual functions of blowing and suction, and can be used for both suction and blowing;

2. Running with little or no oil, the output air is clean;

3. Compared to centrifugal fans and medium pressure fans, their pressure is much higher, often more than ten times that of centrifugal fans;

4. If the pump body is die cast as a whole and shockproof mounting feet are used, the requirements for the installation foundation are also very low. It can even operate normally without fixing the feet, which is very convenient and saves installation costs and installation cycles;

5. Compared to similar fans, its operating noise is lower, and a low-noise high-pressure fan is introduced:

6. Maintenance free use; Its consumable parts are only two bearings, which basically do not require maintenance within the warranty period;

7. The mechanical wear of high-pressure fans is very small because there are no other mechanical contact parts besides the bearings, so the service life is naturally very long. As long as it is under normal operating conditions, there is no problem for 3-5 years;

8. Easy to install and use!

High temperature resistant gas ring blower, thermal circulation conveying gas vortex pump

Structural features: The fan is mainly composed of impeller, casing, air inlet, motor, connector, heat dissipation fan blades and other components. The impeller adopts a multi blade single inlet centrifugal impeller, made of high-quality galvanized or cold-rolled steel plates, and the blades are designed based on aerodynamic principles. The WQE type impeller consists of 10 aft tilting airfoil blades, a curved front plate, and a flat rear plate. The material is made of high-quality steel plates with high strength and durability, and has undergone strict dynamic and static balance correction. It has good air performance, high efficiency, and smooth operation. The air inlet adopts a convergent streamlined vortex reduction form, which reduces airflow loss and improves the efficiency of the fan. The fan casing is connected to the motor through a metal casting, and the motor shaft head is equipped with a cooling fan blade. The outer wall of the metal casting has high inlet and outlet pipe interfaces to cool the metal casting and shaft head, ensuring that the motor operates normally at high temperatures. The motor adopts a special high-temperature motor, and the fluid part of the fan is made of heat-resistant materials, with reliable cooling structure performance. Compared to boiler induced draft fans, it has the advantages of simple structure, easy maintenance, and high cost-effectiveness.